1 January 2015 in Applied Thermal Engineering
1 May 2013 in International Journal of Thermal Sciences
18 August 2009 in IEEE Transactions on Industrial Electronics
The design of variable-speed electrical machines involves several fields of physics, such as electromagnetism, thermics, mechanics, and also acoustics. This paper describes the analytical multiphysics models of a computer-aided-design software which is applied to inverter-fed traction induction machines. The electromagnetic model computes rotor and stator currents, the induction-machine traction characteristics, and the radial air-gap flux density. The mechanical and acoustic models compute the motor's audible magnetic noise level due to Maxwell forces. The thermal model based on 3-D nodal network computes the transient temperature of different parts of the motor. These fast models make it possible to couple the software with some optimization tools. Some simulation results are presented on a self-ventilated closed motor and compared to experiments.
26 February 2014 in Journal of Heat Transfer
1 January 2007 in Experimental Thermal and Fluid Science
3 April 2012 in IEEE Transactions on Industrial Electronics
ABAugusto Salomao Bornschlegell
Augusto Salomao Bornschlegell
An optimization of the thermal behavior of a high-power salient-pole electrical machine is presented. Temperatures are calculated with the lumped method, which provides the thermal trends with relatively low computational cost. This model is used to define an aggregated objective function of our nonlinear thermal optimization problem by combining the mean solid temperature with the maximum temperature criteria. The 13 design variables correspond to the main volumetric flow rates in the electrical machine, which are bounded and subjected to a nonlinear constraint, assuming a fixed geometry. Two MATLAB optimization algorithms were tested: the Active-set (FMINCON solver) and the genetic algorithm (GA). Due to the strong nonlinearities of the model and the resulting nonconvex optimization problem, the GA is likely to give better results. Minimizing the mean solid temperature was demonstrated to be more important than the maximum temperature criterion. A strategic flow configuration is found to send fresh air to the second half of the cooling circuit, where air usually arrives heated. This optimal configuration provides better cooling than its current modeled configuration. This methodology should be of interest during the development phase.