Yuliia Kovalchuk

Yuliia Kovalchuk

Auto-generated profile, based on publicly available information

Yuliia Kovalchuk

Kyiv National University of Construction and Architecture

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 March 2018 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
VBVolodymyr Biletsky
Volodymyr Biletsky
VVVitaliy Vitryk
Vitaliy Vitryk
YMYuliya Mishchuk
Yuliya Mishchuk
MFMykhailo Fyk
Mykhailo Fyk
ADAndriy Dzhus
Andriy Dzhus
AYAndriy Yurych
Andriy Yurych
By using the module Flow Simulation from the programming environment SolidWorks, we obtained parametric fields of turbulent flow of drilling mud in the subject of research – a power section of the screw down-hole motor (SDM). The subject of research is the characteristics of turbulence of the drilling mud flow. An analysis of the obtained model parametric fields of turbulent flow of drilling mud in the power section of SDM shows two distinctive regions that differ by the characteristics of turbulence in the drilling mud current. These sections are localized in the neighborhood of contact points "rotor-stator", and along the distance between these points. In the first section, the developed flow turbulence almost disappears; the dissipation of flow energy significantly decreases. In the second section, there is a developed turbulence of drilling mud, which causes increased dissipation of flow energy and a possible damage to the stator by a solid phase of drilling mud. Vorticity of drilling mud in this region reaches the maximum values of 1,875.7 s-1. Turbulent time scale in the second region reaches the minimum values of 0.001 s, and the metrical scale of pulsations is comparatively small – from 0.011 to 5.666 m, indicating the presence of small-scale turbulent vortices and the elevated dissipation of flow energy. Thus, the second section is the most vulnerable to a damage to the stator by a solid phase of drilling mud. An endoscopic examination of the surface of the SDM stator, which we conducted, revealed damage to its working surface, specifically deep scratches, guide scratches, cavities. Localization of damage is from the middle and to the tail part of the power section at a distance of 2.53−4.78 m from the beginning of the power section of SDM.The models obtained are recommended for using in hydraulic calculations of SDM, for choosing a rational mode of its operation

1 January 2023
Verified
Book Chapter
Closed access
PDF file
VGV. Grechanyuk
V. Grechanyuk
MGM. Grechanyuk
M. Grechanyuk
VCV. Chornovol
V. Chornovol
AKA. Kozyrev
A. Kozyrev
KYKovalchuk Yu
Kovalchuk Yu

4 May 2023
Verified
Conference Paper
Closed access
OYOlha Yudicheva
Olha Yudicheva
OBOksana Bondar-Pidhurska
Oksana Bondar-Pidhurska
AGAlla Glebova
Alla Glebova
LALiudmyla Alaverdian
Liudmyla Alaverdian
OROlesia Romanenko
Olesia Romanenko
YKYuliia Kovalchuk
Yuliia Kovalchuk
In the article, the authors highlight the advantages and summarize the experience of using information and communication technologies in the educational process of higher education institutions of central Ukraine, namely: Kyiv University of Civil Engineering and Architecture, Ukoopspilka University of Economics “Poltava University of Economics and Trade” and National University “Poltava Polytechnic named after Yury Kondratyuk” in the conditions the COVID-19 pandemic and the Russian Federation's war against Ukraine. It has been proven that the use of these information and communication technologies contributes to the organization of the educational process in the conditions of new challenges and threats in educational institutions. It is noted that higher education institutions of Ukraine have a sufficient number of high-quality information and communication technologies, successfully solve the problems of organizing distance learning and adapt to new challenges and threats during the period of war and pandemic in the conditions of the development of the digital economy. The analysis of the use of distance learning information and communication technologies among students of various educational and professional programs is determined as a perspective for further research.

2 January 2026
Verified
Book Chapter
Closed access
PDF file
IGI. Grechanyuk
I. Grechanyuk
VGV. Grechanyuk
V. Grechanyuk
AKA. Kozyrev
A. Kozyrev
OMO. Matsenko
O. Matsenko
KYKovalchuk Yu
Kovalchuk Yu

30 December 2024 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
YFYuriі Franchuk
Yuriі Franchuk
VKVolodymyr Kosilov
Volodymyr Kosilov
YKYuliia Kovalchuk
Yuliia Kovalchuk
The object of this study is a gas mixture of natural gas and hydrogen. The physical and chemical parameters of fuel mixtures of natural gas with hydrogen have been investigated with the aim of further regulating the hydrogen content in the gas transmission system in accordance with the state standards of Ukraine and the European Union. The task addressed was the safe use of green hydrogen in a mixture with natural gas. The permissible hydrogen content in municipal network gas was established at 7 mol %, which would allow efficient and safe use of existing gas transmission systems. Currently, a 4 % increase in pressure is recommended for low-pressure networks. This is because the calorific value of natural gas is regulated by the Code of Gas Transmission and Distribution Systems and must be within certain limits, and compliance with this particular hydrogen content in natural gas allows this indicator to be kept within the normal range. The 4 % increase in pressure is due to the preservation of the thermal power of gas burners when one gaseous fuel is replaced by another. The content of the mixture of combustible gases at the lower and upper flash points was analyzed. It was found that at 7 % hydrogen content, the flash point range is 5.07–16.75 vol %, which is within the permissible range of 5–15 vol %. With an increase in the hydrogen content of the gas, an explosion may occur in a wider range of concentrations and require additional safety measures. The defined hydrogen limit does not affect the explosiveness of network gas and ensures the safety of its use since the lower concentration limit of flammability (in terms of methane) in a mixture with air in volume percentage is 4.4, and the upper limit is 17.0 vol % according to Annex 2 of the technical regulations

31 August 2022 in Technology audit and production reserves
Verified
Journal Article
Open access
PDF file
YKYuliia Kovalchuk
Yuliia Kovalchuk
VSViktor Svitlytskyi
Viktor Svitlytskyi
OIOlga Ivankiv
Olga Ivankiv
VSValentin Shinkarenko
Valentin Shinkarenko
IBIrуna Boshkova
Irуna Boshkova
One of the important problems of the oil and gas industry is the decrease in the production characteristics of wells in fields that are at the final stage of development. In addition, the drop in well production below their potential and the decrease in hydrocarbon recovery factors are often due to the deterioration of the reservoir properties of rocks in the process of drilling in productive formations, well workover, as well as the imperfection of production processes and means of their implementation. The object of research is the technology of treatment of the bottomhole formation zone with non-acidic systems based on ammonium salts for the intensification of hydrocarbon production. The paper considers a number of methods that allow solving the above problems, taking into account their complexity, efficiency and duration of the positive effect of processing. The main acid methods of influencing the bottomhole formation zone and their modifications are analyzed. The authors, using the results of the research and experience gained, proposed a non-acidic system of chemical treatment of oil and gas wells based on ammonium salts. Their influence on the rocks occurs more long-term and does not lead to the destruction of reservoirs. During the research, physical, chemical, physicochemical methods and techniques developed by the authors for processing and analyzing field data, statistical methods for processing experimental studies were used. Modeling of deep processes was carried out on the installation developed and created by the authors. The mechanism of interaction of ammonium salt solutions with terrigenous and carbonate rocks is revealed. Experimental studies have confirmed and theoretically substantiated the effectiveness of the use of ammonium salts to improve the filtration characteristics of reservoirs. The effect of ammonium salt solutions on the change in the permeability of sandy and carbonate reservoirs in the Dnipro-Donetsk depression (DDD, Ukraine) has been studied. And also a mathematical model of the process of increasing the permeability of rocks during their dissolution by the studied chemical reagents was created. The mathematical model is available for its wide application in the practice of technological calculations and designing measures for the stimulation of oil and gas production.