1 January 2000 in International Journal of Fluid Power
The paper deals with an application of a simplified numerical analysis, based on Computational Fluid Dynamics (CFD), of the flow field inside the compensated port connections of a reference spool valve. The aim of the study was to evaluate a proposed analysis procedure, for the major effects related to the presence of steady state flow forces affecting the spool equilibrium. Starting from an initial summary of the dimensional analysis proposed by the authors to approach the application of CFD to hydraulic components, the paper presents the results of three commonly used compensating profiles for two reference spool positions. In order to validate the simulation, the curves obtained for one of the three geometries are compared with the experimental data obtained on an equivalent port connection of a commercial distributor.
1 January 2005 in International Journal of Fluid Power
The paper presents theoretical and experimental results of studies on the influence of shape and number of spool notches on the discharge characteristics (discharge coefficient, velocity coefficient and flow angle) of a hydraulic distributor metering edge. The flow-rate vs. pressure drop and the steady state axial flow-force vs. pressure drop diagrams are determined for spools with different configurations of multiple notched metering edges. Various combinations of the shape and number of the notches modulating the metering area of the passage between supply and drain ports were investigated and correlated with flow-rate, axial flow-force and pressure drop, in order to get estimates of discharge coefficient and flow angle. The procedure is applied to all the data collected during the experimental activity, and shows the behaviour of the flow characteristics in both the fully turbulent and transitional region of motion. The influence of notch shape and number on the metering edge flow characteristics is evaluated as well.
23 February 2015 in International Journal of Fluid Power
1 June 2013 in Journal of Terramechanics
1 July 1998 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
This paper presents some results obtained during the computational fluid dynamics (CFD) analysis of internal flows inside a hydraulic component, using a scaling technique applied to numerical pre- and post-processing. The main aim of the work is to demonstrate the reduction of computational work needed for a complete analysis of component behaviour over a wide range of operating conditions. This result is achieved through the adoption of a methodology aimed at giving the highest level of generality to a non-dimensional solution, thereby overcoming the two major limitations encountered in the use of CFD in fluid power design: computer resources and time. In the case study, the technique was applied to a hydraulic distributor and computations were performed with a commercial computational fluid dynamics code. The key factor of this technique is the evaluation, for a given distributor opening, of the Reynolds number of the flow in the metering region. Provided that this number is high enough to ensure that the discharge coefficient has reached its asymptotic value, the characterization of the flow by a single non-dimensional numerical run can be shown. The theoretical contents of the analysis of the re-scaling technique, which focuses on the engineering information necessary in component design, are described in detail. The bases for its subsequent application to actual cases are then outlined. Finally, a fairly close correlation between numerical results and experimental data is presented.
1 January 1992 in Journal of Terramechanics