Dulal Hosen

Dulal Hosen

Auto-generated profile, based on publicly available information

Dulal Hosen

Department of Textile Engineering, Mawlana Bhashani Science and Technology University, Tangail-1902, Bangladesh

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2021 in Cleaner Engineering and Technology
Verified
Journal Article
Open access
DHDulal Hosen
Dulal Hosen
FRFazla Rabbi
Fazla Rabbi
ARAbu Raihan
Abu Raihan
AMAbdullah Al Mamun
Abdullah Al Mamun

13 June 2022 in Journal of Cleaner Production
Verified
Journal Article
Closed access
DHDulal Hosen
Dulal Hosen
SHShebbir Hossain
Shebbir Hossain
MIMd Azharul Islam
Md Azharul Islam
Abu Naser Md Ahsanul HaqueAbu Naser Md Ahsanul Haque
Abu Naser Md Ahsanul Haque
Maryam NaebeMaryam Naebe
Maryam Naebe

25 October 2022 in Heliyon
Verified
Journal Article
Open access
AMA.T.M. Gulam Moula
A.T.M. Gulam Moula
DHDulal Hosen
Dulal Hosen
ASAbu Bakar Siddiquee
Abu Bakar Siddiquee
AMAbdul Momin
Abdul Momin
ZKZihan Kaisar
Zihan Kaisar
AIAzharul Islam
Azharul Islam
The significance of textile coloration is inevitable as coloration is a critical process and it can be affected by several parameters i. e. time, temperature, pH, and liquor ratio (M:L). This research reveals the behavior of different dye bath pH (2 to 12) on the basis of spectrophotometric characteristics and colorfastness using the most useable brand of reactive dye in Bangladesh i. e. Remazol Yellow RR. Earlier researches were performed on the basis of other coloration controlling factors i. e. temperature, time and liquor ratio (M:L) where pH acts as the dependent variable. However in this study, pH was taken as an independent variable where lower pH (2, 4 and 6), medium pH (8 and 10) and higher pH (12) were taken into consideration for verifying the dyeing performance. Meanwhile, the mentioned pH was achieved by adding acetic acid, soda ash and caustic soda respectively. In this study, the impact of pH is analyzed on the basis of color strength, chromaticity, hue angle, CIELAB color space, spectrophotometric image, reflectance percentage and color fastness tests i. e color fastness to rubbing, color fastness to wash, color fastness to perspiration, color fastness to light. Gradually elevated pH boosts up the color strength and chromaticity, at the same time downgrades of hue angle results orangish tone in the dyed fabric. Even more, the lightness of dyed fabric decreases and redness rises with the increment of dyebath pH which results in orangish red darker tone of dyed fabric. Consequently, fabric dyed at acidic dye bath pH exhibits higher resistance in case of color change and color staining from the dyed fabric and multifiber fabric respectively and vice versa.

1 January 2024 in Advances in Polymer Technology
Verified
Journal Article
Open access
NSNura Alam Shiddique
Nura Alam Shiddique
KIKhairul Islam
Khairul Islam
Tarikul IslamTarikul Islam
Tarikul Islam
DHDulal Hosen
Dulal Hosen
MIMd Azharul Islam
Md Azharul Islam
GBGajanan Bhat
Gajanan Bhat
This study aims to convert cotton‐based post‐consumer textile waste to biodegradable paper, which not only addresses the discarding of waste but also provides a second use of cotton. The post‐consumer garment made with cotton was decolorized by stripping with concentrated NaOH and hydrose. Afterwards, it was chopped, ground, and treated with NaOH solutions. The paper was prepared through a wet‐laid process by mixing carboxymethyl cellulose as a binder with chopped cotton textiles. To reduce water absorbency, the uncoated paper was coated with thermoplastic polyurethane (TPU) using heat pressing technique. The surface morphology and chemical structure of uncoated pristine paper, coated paper, and TPU films were conducted using SEM and FTIR studies. The tensile strength, contact angle, air permeability, and biodegradability tests were investigated according to the standard methods. The tensile properties of the papers were increased after TPU coating, accounting well around 28% compared to the uncoated pristine paper. The elongation at the break of the coated paper was at least 40% greater than the uncoated pristine paper. The coated paper displayed a higher water contact angle of 100°, even after 10 min. The lower air permeability was observed in the coated paper due to TPU film blocking the free spaces of the paper. The TPU‐coated paper exhibited a weight loss of 48.1%–59.8% after 90 days, whereas the uncoated paper was 100% decomposed after 60 days. The burning of post‐consumer cotton textile waste (PCCTW) paper generated ashes resembling those of burning paper, implying clean and environmental friendly biodegradation. The papers can replace the petroleum–plastic materials and serve as food and other packaging applications.

17 December 2023 in Heliyon
Verified
Journal Article
Open access
AMA.T.M. Gulam Moula
A.T.M. Gulam Moula
AMAbdullah Al Mamun
Abdullah Al Mamun
HKHumayun Kabir Khan
Humayun Kabir Khan
DHDulal Hosen
Dulal Hosen
ASAbu Bakar Siddiquee
Abu Bakar Siddiquee
The aim of this study is to analyze the use of vitamin E to enhance fabric's hand feel, moisture management and fabric strength which are affected due to flame retardant finish. Flame retardant treated fabrics typically become stiff, but the addition of Vitamin E along with emulsifier and binding agent through a vertical padding mangle by two times dipping and nipping results a soft fabric without impairing the flammability properties as determined by 45-degree flammability test. The samples were characterized by FTIR spectra, SEM images, and water contact angle. A new characteristics band is appeared at 1455 cm-1 for skeletal vibration of phenyl ring system of alpha tocopherol for Vitamin E measured by Fourier transform infrared spectroscopy (FTIR) that proves the effective attachment of vitamin E with fabric. Hydrophilicity of vitamin E containing sample is discovered after showing 37.629° as a water contact angle at optical tensiometer (Attension theta lite). Additionally, fabric comfort properties, moisture management properties, and mechanical properties were measured by fabric touch tester (FTT), moisture management tester (MMT) machine and tensile strength tester respectively that demonstrate significant affirmative change in almost all indexes of FTT, 43.5 % increase of overall moisture management capacity by MMT and 23 % increase of tear strength by tensile strength tester due to use of vitamin E that effectively compensate lower strength, poor fabric comfort, and low moisture management capability of flame retardant treated fabric.

1 July 2025 in Green Technologies and Sustainability
Verified
Journal Article
Open access
NMNeaz Morshed
Neaz Morshed
AHAbdul Hannan
Abdul Hannan
DHDulal Hosen
Dulal Hosen
Zakaria AhmedZakaria Ahmed
Zakaria Ahmed
SSShamsuzzaman Sheikh
Shamsuzzaman Sheikh
GMGolam Murshed
Golam Murshed