23 January 2024 in Nature Reviews Earth & Environment
TTThe Firn Symposium team
+30
1 September 2022 in Annals of Glaciology
The density structure of firn has implications for hydrological and climate modelling and for ice shelf stability. The firn structure can be evaluated from depth models of seismic velocity, widely obtained with Herglotz-Wiechert inversion (HWI), an approach that considers the slowness of refracted seismic arrivals. However, HWI is appropriate only for steady-state firn profiles and the inversion accuracy can be compromised where firn contains ice layers. In these cases, Full Waveform Inversion (FWI) can be more successful than HWI. FWI extends HWI capabilities by considering the full seismic waveform and incorporates reflected arrivals, thus offering a more accurate estimate of a velocity profile. We show the FWI characterisation of the velocity model has an error of only 1.7% for regions (vs. 4.2% with HWI) with an ice slab (20 m thick, 40 m deep) in an otherwise steady-state firn profile.
29 October 2024 in The Cryosphere
We analyse ambient-noise seismic data from 23 three-component seismic nodes to study firn velocity structure and seismic anisotropy near the EastGRIP camp along the Northeast Greenland Ice Stream (NEGIS). Using nine-component correlation tensors, we derive dispersion curves of Rayleigh and Love wave group velocities from 3 to 40 Hz. These velocity distributions exhibit anisotropy along and across the flow. To assess these variations, we invert dispersion curves for shear wave velocities (Vsh and Vsv) in the top 150 m of the NEGIS using a Markov chain Monte Carlo approach. The reconstructed 1-D shear velocity model reveals radial anisotropy in the firn, with Vsh 12 %–15 % greater than Vsv, peaking at the critical density (550 kg m−3). We combine density data from firn cores drilled in 2016 and 2018 to create a new density parameterisation for the NEGIS, serving as a reference for our results. We link seismic anisotropy in the NEGIS to effective and intrinsic causes. Seasonal densification, wind crusts, and melt layers induce effective anisotropy, leading to faster Vsh waves. Changes in firn recrystallisation cause intrinsic anisotropy, altering the Vsv / Vsh ratio. We observe a shallower firn–ice transition across the flow (≈ 50 m) compared with along the flow (≈ 60 m), suggesting increased firn compaction due to the predominant wind direction and increased deformation towards the shear margin. We demonstrate that short-duration (9 d minimum), passive, seismic deployments and noise-based analysis can determine seismic anisotropy in firn, and we reveal 2-D firn structure and variability.
25 May 2023 in Journal of Glaciology
The density structure of firn has implications for hydrological and climate modelling, and ice-shelf stability. The structure of firn can be evaluated from depth models of seismic velocity, widely obtained with Herglotz–Wiechert inversion (HWI), an approach that considers the slowness of refracted seismic arrivals. However, HWI is strictly appropriate only for steady-state firn profiles and the inversion accuracy can be compromised where firn contains ice layers. In these cases, full waveform inversion (FWI) may yield more success than HWI. FWI extends HWI capabilities by considering the full seismic waveform and incorporates reflected arrivals. Using synthetic firn density profiles, assuming both steady- and non-steady-state accumulation, we show that FWI outperforms HWI for detecting ice slab boundaries (5–80 m thick, 5–80 m deep) and velocity anomalies within firn. FWI can detect slabs thicker than one wavelength (here, 20 m, assuming a maximum frequency of 60 Hz) but requires the starting velocity model to be accurate to ±2.5%. We recommend for field practice that the shallowest layers of velocity models are constrained with ground-truth data. Nonetheless, FWI shows advantages over established methods, and should be considered when the characterisation of firn ice slabs is the goal of the seismic survey.
22 August 2025 in Seismological Research Letters
The grounding zone of a marine-terminating glacier, where ice begins to float, is a key control on glacier stability and ice discharge. Seismic deployments are a powerful means of studying both the geometry and processes of grounding zones; however, these regions are frequently inaccessible and dangerous for field work, and as a result are underrepresented in field studies. We report new data sets acquired at Eastwind Glacier, Antarctica, a relatively accessible grounding zone near McMurdo Station and Scott Base, as part of the Eastwind Glacier Geophysical Surveys on Top of an Antarctic Ice Shelf Transition, EGGS on TOAST, project. These data sets comprise a deployment of three-component seismic nodes and distributed acoustic sensing. The nodal deployment consisted of 330 nodes crossing the grounding zone, with all 330 nodes continuously recording for at least nine days, and 150 nodes recording for 19 days, in the austral summer of 2022/2023. Hammer-and-plate sources were recorded, with densely spaced shots along flow through the center of the array and shots located at every node. In 2023/2024, a 2.2 km fiber-optic cable was deployed for active source imaging by distributed acoustic sensing along and across flow, immediately downstream of the grounding line, for a period of 2 hr. Analysis of active source data recorded by the nodal array locates the point of flotation within the grounding zone and provides ice thickness estimates. We present initial analyses of passive source data, including icequake detection and location, and ambient noise analysis. We expect this data set to be of significant value to provide insight into fundamental grounding zone processes and as an event-rich cryoseismological data set on which to test novel methods of seismic analysis.
12 February 2024 in Nature Reviews Earth & Environment
TTThe Firn Symposium team
+30