1 February 2022 in International Journal of Fatigue
21 October 2022 in Engineering Fracture Mechanics
6 July 2023 in Journal of Materials Processing Technology
5 July 2025 in International Journal of Fatigue
1 January 2015 in Procedia Engineering
International audienceHot riveting was largely used as method of assembly in France during the appearing and expansion of the railway network (1840-1940). Present in wrought iron and steel constructions, riveted connections are commonly found in the French railway heritage. Conceived as a permanent assembly, these connections work by the shearing of the rivets and the friction between the plates, such friction is caused by the clamping force due to the cooling of the rivet after forging. The mechanical behavior of the assembly will depend on the many parameters involved in the process. However, three main failure modes have been identified: tension on the plates, shearing of the rivet and bearing in the plates (pressure of rivet on the rivet hole). To understand the influence of friction in the global behavior of the assembly, a comparison between two types of S235 steel specimens is proposed. The first was a set of several hot riveted specimens and in the second one, the rivet was replaced by a martensitic stainless steel axis with a high yield stress that kept the pieces of the connection in place (no clamping force was thus present this time). The behavior of both types of specimens was then studied in tension using 3D Digital Image Correlation to analyze local and global displacements. The comparison between the relative displacements of the connected plates of the two types of specimens allows identifying the influence of friction in the global behavior. To complete this kinematics investigation, failure scenarios are described through longitudinal cross sections analysis
1 January 2015 in Procedia Engineering
International audienceBeing the second oldest railway network in Europe, almost half of the metallic railway bridges in France were built before the 1900s. At the time, puddled iron was the building material of preference amongst most engineers, hot riveting was the preferred joining method.Considering the ageing of these constructions, as well as the increasing evolution of traffic in the network, the understanding of the behaviour of this type of structures to cyclic loadings is of utmost importance. However, high cycle fatigue characterization is an expensive and time consuming process. The use of a fast characterization method through the measure of self-heating of the specimens during cycling loadings is proposed and analysed.For homogeneous materials, like modern steel, the use of self-heating measurements to estimate fatigue-life related properties has shown good correlation to results obtained by the standard fatigue tests with the advantage of a lower time of characterization. In our case, non-metallic inclusions present in the puddled iron will have an important influence in the response of the material, and therefore the interpretation of the temperature's evolution needs a different approach.Due to its complexity, the integrity of the structure must be analysed from a multi-scaled point of view. For this study, we focused in the quantification of the influence that the population of non-metallic inclusions have on the mechanic and thermal behaviour of a puddled iron. For this purpose, a set of specimens previously tested by the self-heating method were prepared and observed using two different tools: a classic optical microscope and a scanning electron microscope. The relationship between geometric parameters of the inclusions found in the specimens and their temperature response to cyclic loadings was shown. The hypothesis of the presence of micro plasticity (dissipative phenomenon) near inclusions was also validated through SEM observations