Loic Morvan

Loic Morvan

Auto-generated profile, based on publicly available information

Loic Morvan

Thales Research and Technology (France)

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 April 2008 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
GBGhaya Baili
Ghaya Baili
FBFabien Bretenaker
Fabien Bretenaker
MAMehdi Alouini
Mehdi Alouini
LMLoïc Morvan
Loïc Morvan
DDDaniel Dolfi
Daniel Dolfi
ISIsabelle SAGNES
Isabelle SAGNES
Excess intensity noise in a low-noise single-frequency class-A VECSEL is experimentally investigated over the frequency range 10 kHz-18 GHz. An analytical model is derived, based on multimode Langevin equations, to describe the observed laser excess noise over the whole bandwidth. From 50 MHz to 18 GHz, class-A operation leads to a shot noise limited relative intensity noise (RIN), namely -155 dB/Hz for 1-mA detected photocurrent, except at harmonics of the cavity free spectral range (FSR). At these frequencies, the excess noise is shown to be due to the amplified spontaneous emission contained in the nonlasing side modes. The measured levels of excess noise correspond to side mode suppression ratios (SMSRs) ranging from 70 to 90 dB, in agreement with the model. At low frequencies, 10 kHz-50 MHz, the observed excess noise spectrum has the expected Lorentzian shape. Its bandwidth increases with the pumping rate to an upper limit given by the cavity photon lifetime. Below this cutoff frequency, we show that the pump RIN is the dominant source of noise, while it is filtered by the laser dynamics above. Finally, our model permits to design a semiconductor class-A laser with an intensity noise limited to the shot noise level over the whole 10 kHz-18 GHz bandwidth.

1 August 2014 in Photonics Research
Verified
Journal Article
Open access
PDF file
GKGaël Kervella
Gaël Kervella
JMJeremy Maxin
Jeremy Maxin
MFMickael Faugeron
Mickael Faugeron
PBPerrine Berger
Perrine Berger
HLHadrien Lanctuit
Hadrien Lanctuit
DDDaniel Dolfi
Daniel Dolfi
We present several laser sources dedicated to advanced microwave photonic applications. A quantum-dash mode-locked laser delivering a high-power, ultra-stable pulse train is first described. We measure a linewidth below 300 kHz at a 4.3 GHz repetition rate for an output power above 300 mW and a pulse duration of 1.1 ps after compression, making this source ideal for microwave signal sampling applications. A widely tunable (5–110 GHz), monolithic millimeter-wave transceiver based on the integration of two semiconductor distributed feedback lasers, four amplifiers, and two high-speed uni-traveling carrier photodiodes is then presented, together with its application to the wireless transmission of data at 200  Mb/s. A frequency-agile laser source dedicated to microwave signal processing is then described. It delivers arbitrary frequency sweeps over 20 GHz with high precision and high speed (above 400  GHz/ms). Finally, we report on a low-noise (below 1 kHz linewidth), solid-state, dual-frequency laser source. It allows independent tuning of the two frequencies in the perspective of the implementation of a tunable optoelectronic oscillator based on a high-Q optical resonator.

25 July 2013 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
JMJeremy Maxin
Jeremy Maxin
GPGregoire Pillet
Gregoire Pillet
BSBastien Steinhausser
Bastien Steinhausser
LMLoic Morvan
Loic Morvan
OLOlivier Llopis
Olivier Llopis
DDDaniel Dolfi
Daniel Dolfi
We report on an opto-electronic oscillator (OEO) widely tunable from 2.5 to 5.5 GHz. It is based on an Er,Yb:glass Dual-Frequency Laser operating at 1.53 μm which naturally provides an electrically-tunable beatnote. Inserted in an optical frequency-locked loop including a long fiber delay line, the laser beatnote reaches a spectral purity comparable to the one obtained with classical fixed frequency OEOs. As the oscillator scheme does not require an RF filter, the tunability is simply achieved by tuning the laser beatnote frequency. A fine optimization of the loop has allowed reaching a -27 dBc/Hz (respectively -108 dBc/Hz) phase noise power spectral density at 10 Hz (respectively 10 kHz) of the carrier with only 100 m optical fiber, this performance being independent of the frequency.

8 December 2004
Verified
Conference Paper
Closed access
LMLoic Morvan
Loic Morvan
MAMehdi Alouini
Mehdi Alouini
AGArnaud Grisard
Arnaud Grisard
ELEric Lallier
Eric Lallier
DDDaniel Dolfi
Daniel Dolfi
JCJean Chazelas
Jean Chazelas
We propose to review two concepts that can be used for target detection and identification in optronic systems: lidar-radar and multipectral polarimetric active imaging. The lidar-radar concept uses an optically pre-amplified intensity modulated lidar, where the modulation frequency is in the microwave domain (1-10 GHz). Such a system permits to combine directivity of laser beams with mature radar processing. As an intensity modulated or dual-frequency laser beam is directed onto a target, the backscattered intensity is collected by an optical system, pass through an optical preamplifier, and is detected on a high speed photodiode in a direct detection scheme. A radar type processing permits then to extract range, speed and profile of the target for identification purposes. The association of spatially multimode amplifier and direct detection allows low sensitivity to atmospheric turbulence and large field of view. We present here the analysis of a lidar-radar that uses a radar waveform dedicated to range resolution. Preliminary experimental results are presented and discussed. For the multispectral polarization active imaging concept, the acquisition, at different wavelengths, of images coded in intensity and in degree of polarization enables to get information about the spectral signature of targets as well as their polarization properties. A theoretical analysis and a experimental validation of this technique are presented. Preliminary experiments, using a monostatic configuration, will be also presented.

1 February 2003
Verified
Conference Paper
Closed access
PDF file
LMLoic Morvan
Loic Morvan
NLN. D. Lai
N. D. Lai
DDDaniel Dolfi
Daniel Dolfi
JHJean-Pierre Huignard
Jean-Pierre Huignard
MBMichel Brunel
Michel Brunel
AFAlbert Le Floch
Albert Le Floch
A new principle of lidar-radar is theoretically and experimentally investigated. The proposed architecture is based on the use of a RF modulation of the emitted light beam and direct detection of the backscattered intensity. The use of a radar processing chain allows to obtain range and Doppler measurements with the advantages of lidar spatial resolution. The maximum range of this device is calculated, taking different possible improvements into account. In particular, it is shown that the use of a pulsed two-frequency laser and a spatially multimode optical pre-amplification of the backscattered light leads to calculated ranges larger than 20 km, including the possibility for both range and Doppler measurements. The building blocks of this lidar-radar are tested experimentally : the radar processing of an RF modulated backscattered cw laser beam is demonstrated at 532 nm, illustrating the Doppler and identification capabilities of the system. Besides, signal-to-noise ratio improvement by optical pre-amplification and filtering of the ASE noise is demonstrated at 1.55 μm. Finally, a two-frequency passively Q-switched Nd:YAG laser is developed. This laser then permits to obtain two-frequency pulses with tunable pulse duration and beat frequency.