1 June 2021 in Physics of Plasmas
New analytical expressions for parallel transport coefficients in multicomponent collisional plasmas are presented in this paper. They are improved versions of the expressions written in Zhdanov [Transport Processes in Multicomponent Plasma, English ed. (Taylor and Francis, London, New York, 2002)], based on Grad's 21N-moment method. Both explicit and approximate approaches for the calculation of transport coefficients are considered. Accurate application of this closure for the Braginskii transport equations is discussed. Viscosity dependence on the heat flux is taken into account. Improved expressions are implemented into the SOLPS-ITER code and tested for deuterium and neon ITER cases. Some typos found in Zhdanov [Transport Processes in Multicomponent Plasma, English ed. (Taylor and Francis, London, New York, 2002)] are corrected.
18 July 2022 in Nuclear Fusion
The Chinese Fusion Engineering Testing Reactor (CFETR) is a project proposed by the Chinese fusion community to bridge the gap between ITER and a commercial fusion power plant with fusion power up to 1 GW. The mitigation of divertor target heat fluxes for such a powerful machine is a challenging problem, which might appear to be more severe than in ITER. In the present paper, the results of the CFETR advanced divertor optimization by SOLPS-ITER modeling with full drifts and currents activated are presented. Three divertor geometries, which differ by the distance from the X-point to the strike point on the outer target, are considered. Argon (Ar) and neon (Ne) are compared as seeded impurities. It is demonstrated that for all three geometries and for both radiators it is possible to achieve acceptable divertor heat loads (below 5 MW m−2) without notable fuel dilution (Z eff < 2.5). Impurity compression in divertors and pedestal radiation are compared for two gases. Similar core plasma and divertor conditions, as well as radiated power fraction, may be achieved with 2–3 times less Ar seeding rate than the Ne one. Estimated radiation from the confined region appears to be small compared to the exhaust power. However, in all modeling cases the T e at the far scrape-off layer part of both targets remains significantly above 5 eV, which might cause tungsten (W) sputtering. Further optimization of target shape will be performed to reduce the electron and ion temperature.
3 January 2023 in Nuclear Fusion
A new Grad–Zhdanov module is implemented into the SOLPS-ITER code for calculation of the parallel kinetic coefficients. A complete, multi-ion generalization is performed, relaxing the heavy impurity assumption. A JET-like D+T+Ne test simulation is conducted to demonstrate the ability to model a 50/50 deuterium (D) and tritium (T) mixture in SOLPS-ITER. More than 30% T build-up with respect to D is observed in different parts of the simulation domain, in particular at the high field side. A T predominance over D is also observed near both the inner and outer targets. It is a result of the different effective diffusion, dominated by charge-exchange processes, for the D and T neutral species. A simple 1D model is proposed to describe this phenomenon. The contribution to the differing D and T distribution in different regions from the Grad–Zhdanov thermal force is also studied. Due to the thermal force and the D/T poloidal flow from the low field side to the high field side, the prevalence of the T species over D is found at the high field side at the X-point level. The latter leads to an inner–outer divertor asymmetry of . However, the effect is relatively small due to the close D and T masses. It is further shown that the infinite ion mass difference limit, which is used for the derivation of the Zhdanov-Yushmanov analytical expressions and applied for the thermal force coefficient calculation previously used in the SOLPS-ITER code, overestimates significantly. Thus, the old SOLPS-ITER model should not be applied for D–T simulations. Finally, possible experimental studies of the D and T spatial separation due to the new effects revealed by this modelling are discussed.
10 March 2025 in Nuclear Fusion
Extrapolating the observed behavior of helium exhaust in current tokamaks towards future reactors requires the understanding of the underlying physical mechanisms determining helium transport, recycling and pumping. Helium compression is the main physics-based figure of merit characterizing how efficiently helium is transported towards the divertor and recycled at the target plates. Moreover, helium gas transport in the subdivertor region towards the pumps is strongly influenced by vessel geometry and installed pumps. The SOLPS-ITER code package is used to model H-mode He-seeded deuterium plasmas at the ASDEX Upgrade tokamak, and compared to recent experiments. The simulations generally indicate a poor recycling of helium in the divertor, compared to that of deuterium, in qualitative agreement with the experiment. This is mainly determined by a deeper edge transport barrier and a weaker parallel SOL transport of He ions, with respect to D ions, and by the higher first ionization energy of He atoms, which results in a deeper penetration of recycled atoms into the plasma. The simulated He compression is, however, much smaller than the experimentally measured one, despite the introduction of additional, non-default physics components into the code. Helium gas transport in the subdivertor region towards the pumps is conductance-limited, but moderately enhanced by the entrainment of He atoms into the stronger, viscous deuterium gas flow via friction. The observed poor helium recycling poses challenges in view of the requirements of helium exhaust in future reactors. Our results emphasize the need to investigate further strategies to optimize helium pumping, to guarantee an efficient removal of helium ash in future burning plasmas. Additionally, the observed difficulty of SOLPS-ITER in reproducing the experimental observations suggests a careful evaluation of the currently available extrapolations of impurity transport towards future devices obtained via edge transport modelling.
29 December 2021 in Contributions to Plasma Physics
New Grad–Zhdanov module is implemented in the SOLPS‐ITER code and applied to ITER impurity transport simulations. Significant difference appears in the helium transport due to improved parallel kinetic coefficients. As a result, 30% decrease of the separatrix‐averaged helium relative concentration is observed for the constant helium source and pumping speed. However, for the neon changes are less pronounce. Change of the impurity behaviour is discussed. For the first time the ion distribution functions are studied in the ITER scrape‐off layer conditions to reveal the origin of the kinetic coefficient improvements and theory limitations.
1 July 2026 in Physics of Plasmas
We present HaGrids, a Hamiltonian model developed to generate computational grids and analyze magnetic field chaos in island divertor configurations. In real space, the configuration represents island chains formed on top of circular flux surfaces. This model is employed to construct field-aligned grids for EMC3-EIRENE simulations by generating a 2D base mesh and performing field-line tracing. Initial simulations compare cases with and without magnetic field chaos. In the chaotic case, strong secondary perturbations create extended chaotic regions at the edge, enabling efficient heat transport from the confined plasma through the chaotic zone to the divertor targets. This leads to flattened radial profiles across the chaotic region and a noticeable reduction in core confinement. In the case studied here, the formation of secondary strike lines, due to turnstile-lobe dynamics, broadens the target heat deposition and reduces the peak heat flux by ∼20%; the precise reduction depends on the perturbation spectrum, target geometry, and transport coefficients. The flexibility of the model allows for the exploration of a wide range of perturbation spectra and target geometries, offering a powerful tool for divertor studies and optimization beyond fixed-coil configurations.