12 May 2022 in Engineering Reports
Through silicon vias (TSVs) are a key enabling technology for interconnection and realization of complex three‐dimensional integrated circuit (3D‐IC) components. In order to perform failure analysis without the need of destructive sample preparation, x‐ray microscopy (XRM) is a rising method of analyzing the internal structure of samples. However, there is still a lack of evaluated scan recipes or best practices regarding XRM parameter settings for the study of TSVs in the current state of literature. There is also an increased interest in automated machine learning and deep learning approaches for qualitative and quantitative inspection processes in recent years. Especially deep learning based object detection is a well‐known methodology for fast detection and classification capable of working with large volumetric XRM datasets. Therefore, a combined XRM and deep learning object detection workflow for automatic micrometer accurate defect location on liner‐TSVs was developed throughout this work. Two measurement setups including detailed information about the used parameters for either full IC device scan or detailed TSV scan were introduced. Both are able to depict delamination defects and finer structures in TSVs with either a low or high resolution. The combination of a 0.4 objective with a beam voltage of 40 kV proved to be a good combination for achieving optimal imaging contrast for the full‐device scan. However, detailed TSV scans have demonstrated that the use of a 20 objective along with a beam voltage of 140 kV significantly improves image quality. A database with 30,000 objects was created for automated data analysis, so that a well‐established object recognition method for automated defect analysis could be integrated into the process analysis. This RetinaNet‐based object detection method achieves a very strong average precision of 0.94. It supports the detection of erroneous TSVs in both top view and side view, so that defects can be detected at different depths. Consequently, the proposed workflow can be used for failure analysis, quality control or process optimization in R&D environments.
2 February 2023 in Advanced Electronic Materials
Advances in organic materials manufacturing have enabled the creation of electronic devices using solution‐processing techniques by employing soluble materials with high conductivity grade. In this exploratory study, the use of micro‐contact for poly(3,4‐ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) polymer ink deposition as high‐quality structured electrodes for organic field‐effect transistors (OFETs) in top‐contact geometry is demonstrated. The optimized OFET's solution‐processed fabrication is a promising strategy to be realized in the simple, cost‐effective roll‐to‐roll manufacturing processes. The electrical performance of the fabricated devices is comparable to transistors with gold electrodes prepared via vacuum deposition, and even exceeding the values of the charge carriers’ mobilities and featuring lower contact resistance (Rc), due to lower charge‐carrier injection barrier for carbon‐based organic electrodes. An addition of multi‐walled carbon nanotubes to the PEDOT:PSS decreases Rc even further, changing the work function for better energy alignment with semiconductor materials.
21 November 2025 in International Journal of Adhesion and Adhesives