1 August 2021 in Journal of Wind Engineering and Industrial Aerodynamics
1 February 2024 in Physics of Fluids
Although the suspension gap between a maglev train and its track is narrow, it has a significant impact on the aerodynamic performance of the train. This study investigated the effect of the suspension gap on the wake flow of a superconducting maglev train traveling at a speed of 600 km/h by comparing the aerodynamics and flow field structure of a tail car (TC) with suspension gaps of 8, 10, 12, and 14 cm. The results showed that with increasing suspension gap, the vortex structures in the wake region move closer to the TC, the airflow from the suspension gap inhibits the high-pressure region of the wake, and the pressure and velocity fluctuations significantly increase near the nose tip of the TC. Moreover, the suspension gap was found to have a significant impact on lift and almost no effect on drag. Increasing the suspension gap leads to a balance in the lift between the head car (HC) and the TC; as the gap continues to increase, the lift ratio of the HC and TC rapidly decreases.
1 February 2023 in Physics of Fluids
As a supersonic transportation system, the flow around a vehicle in an Evacuated Tube Transportation (ETT) system will evolve through series of flow structures during acceleration. The occurrence of choked flow and shock wave will especially lead to the drastic change in flow field structures. In this study, based on the one-dimensional inviscid flow assumption, a theoretical model is established to quantitatively describe the formation time, formation location of choked flow, and Frontal Normal Shock Wave (FNSW), as well as the distance of the disturbed flow field region ahead of the vehicle in the ETT system. It is found out that the formation time of FNSW as well as the initial distance between the vehicle head and FNSW is linearly proportional to the blockage ratio while linearly inverse proportional to the acceleration rate of the vehicle. An experimentally verified numerical model is also established with an overset mesh technique to investigate the flow field evolution for vehicles accelerating in the ETT system. The results from numerical analysis agree well with the theoretical model. Meanwhile, five typical flow field structures are summarized for a vehicle accelerating from a stationary state to supersonic state in the ETT system. The applicability of the wind tunnel method and overset mesh technique in numerical simulation of the ETT system is systematically discussed. The influence of occurrence and dissipation of choked flow and shock wave on the vehicle's aerodynamic drag profile are then analyzed quantitatively.
1 March 2025 in Physics of Fluids
The high-speed maglev train in the tube transportation system will induce supersonic flow at subsonic traveling speed. Within this process, the dynamic transition of the flow field has a significant impact on the aerodynamic load of the vehicle. This research focuses on the flow field transition characteristic with respect to the tube train's accelerating and decelerating process. The quasi-steady wind tunnel simulation method with stepwise acceleration, as well as the transient overset mesh simulation method with constant acceleration and deceleration, has both been used and compared in this study. Based on the results derived from the stepwise acceleration approach, during the accelerating stage, the dissipation of choked flow follows the critical condition given by the Kantrowitz limit, while for the decelerating stage, the occurrence of choked flow follows the critical condition given by the isentropic limit. On the other hand, for a vehicle accelerating and decelerating at a constant rate, a hysteresis between the flow field and vehicle speed for the vehicle's acceleration and deceleration process can be observed. It is found that, for vehicles with a constant decelerating rate, the absolute airflow velocity ahead of the vehicle will decrease and even reverse direction for a certain period of time, which leads to a situation when the aerodynamic drag of the vehicle's streamlined head is aligned with the vehicle's moving direction. It is also discovered that, as the vehicle decelerates from a supersonic state without choked flow to a transonic state with choked flow, under the interaction between the oblique shock wave and the expansion wave, the aerodynamic load in the streamlined tail will first decrease and then increase.
1 September 2026 in Physics of Fluids
The self-starting of a hyperloop pod, characterized by the transition from a choked to an unchoked flow state during acceleration, can substantially reduce aerodynamic drag. This study develops a quasi-one-dimensional inviscid theoretical model to elucidate the underlying self-starting mechanism. The model describes the propagation of compression waves and the frontal normal shock wave (FNSW) ahead of the pod and provides analytical solutions for the coupled velocity, temperature, and pressure fields within the disturbed region. Furthermore, numerical simulations are conducted using a two-dimensional axisymmetric model with an overset mesh technique. The SST k–ω URANS-based numerical model is validated against wind tunnel experimental data and published three-dimensional simulation results. The present theoretical predictions are cross-validated against the numerical results, showing a maximum deviation of 2.8% for the FNSW. The results indicate that self-starting is governed primarily by the relative distance between the pod and the FNSW. Within the investigated range, acceleration mainly affects the rate of flow field and aerodynamic drag evolution but does not determine whether self-starting occurs. Under the uniform acceleration assumptions, self-starting is achieved only when the blockage ratio, defined as the maximum pod cross-sectional area divided by the tube cross-sectional area, is below 0.21. This conditional threshold provides guidance for pod–tube dimensional matching and aerodynamic safety.