As extensive renewable energy-based distributed generators (DGs) are integrated into the microgrids (MGs), system inertia drops sharply, posing enormous challenges to power quality. Inspired by the conventional synchronous generator(SG), a novel control structure called virtual synchronous generator (VSG) is proposed to provide ancillary rotor regulation. Moreover, existing distributed control algorithms highly rely on explicit state sharing, which exposes MGs to potential privacy leakage threats. To this end, a distributed self-triggered privacy-preserving secondary control of VSG-based AC MGs is proposed to achieve control objectives while protecting the initial and real-time values. First, VSG is modeled by mimicking the operation of SG to provide inertial and damping support for MGs. Considering the nonlinear dynamic characteristics of VSGs, a novel VSG-integrated distributed secondary control strategy with inertial-support is established to achieve control objectives. Moreover, we present a more comprehensive definition of privacy preservation. Next, a Paillier encryption-based privacy-preserving algorithm is innovatively developed to tackle the potential data disclosure problems that need to be faced when performing continuous information interaction. Further, to attenuate the effect of extra encryption costs, we propose a self-triggered mechanism to significantly reduce 86% communication resources. Finally, the superior performance of the proposed strategy is testified by numerical case studies.
23 January 2024 in IEEE Transactions on Industrial Electronics
Wireless power transfer technology is widely used for wireless electric vehicle chargers (WEVC) due to its safety, flexibility, and convenience. However, there is an inevitable misalignment between the transmitter and receiver of WEVC, which reduces the efficiency and stability of power transfer significantly. To this end, this article proposes a receiver position detection (PD) system based on the novel active beacon structure to improve the transfer performance of WEVCs. First, the novel beacons are activated to detect the receiver misalignment accurately before power transfer, which are placed on the vehicle side. Meanwhile, the PD coil matrix is employed on the ground side to achieve large-area and precise misalignment detection. Then, the parameters of PD circuits are optimized to reduce the sampled voltage errors correspondingly. In addition, with the aid of the proposed system structure, a weighted centroid PD algorithm is given to calculate the position of the receiver. Finally, the feasibility of the proposed PD system is verified by using an experimental prototype. The experimental results achieve an offset detection accuracy of 3 mm in the area of 600 mm×480 mm and a yaw angle detection accuracy of 2 $^{\circ }$ in the area of 120 mm×480 mm.
To ascertain the influence of gases temperature on the viscosity and flow velocity of melt in the gas-assisted extrusion forming of plastic micro-tube, the three phase fluid geometric model was established and the finite element numerical simulation method was used in this paper. In the simulations, four different assisted-gases temperatures were imposed on the inlet boundaries of inner and outer assisted gas layers. Under a certain inlet volume flow rate of melt and assisted gases, as well as the thermal boundaries conditions, the numerical results about the effect of gases temperature on the viscosity and flow velocity of melt for the gas-assisted extrusion forming of the plastic micro-tube were obtained. Results show that with the increase of gases temperature, the viscosity distribution of melt in the radial direction of die channel decreases. However, at the axial direction of die channel, when the gases temperature is less than that of the melt, the viscosity of melt increases first and then decreases finally increases outside of die. When the gases temperature is larger than that of melt, the viscosity of melt decreases first and then increases finally increases outside of die. In addition, the flow velocity of melt increases with the gases temperature.