In this work, niobium oxide films were deposited by reactive magnetron sputtering under different oxygen flow rate and applied as electron transport layer in perovskite solar cells. It was found that the deposition made using 3.5 sccm of oxygen flow resulted in films with better electrical properties which helped the extraction of the photogenerated electrons to the external circuit, improving the Jsc and consequently the device efficiency. In addition, by photoluminescence measurements, we found a better charge transfer from perovskite to TiO2/niobium oxide film deposited at 3.5 sccm of oxygen flow.
Two different methods are used to deposit Nb2O5 as compact electron transport layers in n-i-p double cation mixed-halide perovskite Cs0.17FA0.83Pb(I0.83Br0.17)3 solar cells: reactive sputtering and spin coating. These different Nb2O5 films influenced perovskite growth and the charge transport in the cells. Photovoltaic parameters were obtained with an average power conversion efficiency of 17.0% and 15.7% for the devices based on sputtered and spin-coated Nb2O5, respectively. The mobility and the extracted charges were higher in sputtered Nb2O5-based devices than in the spin-coated ones. This effect is attributed to the larger grain sizes observed in the perovskite films when deposited onto the sputtered Nb2O5 layers. The higher densities of grain boundaries in the spin-coated Nb2O5-based devices increase ion diffusion and are expected to decrease efficiency.
30 November 2021 in Journal of Vacuum Science & Technology A
The influence of the oxygen gas supply on the stoichiometry, structure, and orientation texture of polycrystalline cobalt oxide films was investigated in this study. The films were grown by direct current reactive magnetron sputtering using a metallic Co target and different O2 inlet flow rates (0.5–5.0 SCCM). The deposition power (80 W), the argon gas flow (40 SCCM), and the total working pressure (0.67 Pa) were kept constant during depositions. The results evidence a strong influence of the oxygen flow over the film’s stoichiometry and structure, where low oxygen flows (2.5 SCCM) favor the spinel Co3O4 phase formation. The coexistence of monoxide and tetraoxide phases is only observed for the 2.5 SCCM oxygen flow condition. Strain effects related to the oxygen partial pressure are also observed and discussed. Computer simulations of the reactive sputtering growth supported the analysis of the film properties and its correlation to the oxygen partial pressure.
28 September 2019 in Journal of Visualized Experiments
Reactive sputtering is a versatile technique used to form compact films with excellent homogeneity. In addition, it allows easy control over deposition parameters such as gas flow rate that results in changes on composition and thus in the film required properties. In this report, reactive sputtering is used to deposit niobium oxide films. A niobium target is used as metal source and different oxygen flow rates to deposit niobium oxide films. The oxygen flow rate was changed from 3 to 10 sccm. The films deposited under low oxygen flow rates show higher electrical conductivity and provide better perovskite solar cells when used as electron transport layer.