Ultra-low-temperature process treatments could raise tool steel wear resistance through microstructural change that occurs on the material, enhancing, that way, tools and dies lifetime. To investigate the tool steel wear resistance impact, micro-abrasive wear tests were carried out and an analysis based on the Archard's law was considered, evaluating specimen mass loss by laser interferometry. Micro-hardness, X-ray diffractometry, scanning and optical microscopy and carbides quantitative evaluation were carried out aiming to material characterisation. Results demonstrated a micro-hardness improvement, ranging from 0.9–4.7% for the cryogenically treated specimens, when compared to the bulk material. This effect is related, mainly, to the retained austenite transformation and to the increase of fine secondary carbides dispersed amount in the martensitic matrixes cryogenically treated.
Low temperature plasma carburizing treatment of austenitic stainless steels is a carbon surface diffusion process for a surface hardness and corrosion and wear resistance. The process is carried out by introducing a mixture of carbon-containing gases and through the use of low temperatures the resulting cemented layer usually contains a single phase of supersaturated austenite with carbon – S-phase. For the present investigation, austenitic stainless steels AISI 316L and 304 were plasma cemented for 8 hours in the gas mixture containing 7.5% CH4 in H2, with a pressure of 500 Pa, at temperatures of 375 ºC and 450 ºC. The phases formed were determined by X-ray diffraction. The corrosion resistance was evaluated through immersion tests over time and cyclic voltammetry. The results indicate that there was no formation of compounds (carbides) in the cemented layer for both steels at any of the temperatures and there was a corrosion resistance improvement.