Hyeokjae Lee

Hyeokjae Lee

Auto-generated profile, based on publicly available information

Hyeokjae Lee

Quality Reliability Technology (QRT) Inc., Yeongtong-gu, Suwon-si, Gyeonggi-do, Republic of Korea

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 May 2023 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
DBDongwoo Bae
Dongwoo Bae
KKKiseog Kim
Kiseog Kim
HLHyeokjae Lee
Hyeokjae Lee
SCSung S. Chung
Sung S. Chung
JKJoongsik Kih
Joongsik Kih
YKYoungboo Kim
Youngboo Kim
We evaluated and analyzed power SiC MOSFETs with gate switching mode during neutron irradiation with our commercial single event effect (SEE) Analyzer. Based on evaluation and analysis, we found i) difference of radiation robustness characteristics, ii) switching mode to be worse condition than non-switching (DC bias condition) mode for 1200 V rated SiC MOSFETs, and iii) temperature dependence with three manufactures’ SiC MOSFETs. In order to clarify the difference between the switching mode and non-switching mode effect, and between the electrical characteristics of the devices, we extracted device-related parameters through physical structure analysis and systematically investigated the cause of the difference by performing simulations with TCAD. As a result, we found that the distribution of electric field according to the gate structure and oxide thickness of SiC MOSFET affects to SiC MOSFET radiation robustness. It was also observed that one of the acceleration factors for increased cross section was higher temperature during irradiation test.

19 November 2002
Verified
Conference Paper
Closed access
HLHyeokjae Lee
Hyeokjae Lee
YHYoonjong Huh
Yoonjong Huh
JGJung-Suk Goo
Jung-Suk Goo
SLSang-Don Lee
Sang-Don Lee
DYDooyoung Yang
Dooyoung Yang
WKWoo Shik Kim
Woo Shik Kim
We report a new junction leakage generation phenomenon which was found at specific junction edges on top of which poly-Si gates ran nearby in a 0.35 /spl mu/m design rule actual DRAM chip. As more advanced isolation schemes that enabled less bird's beak were applied, the phenomenon was more evident. After characterizing a set of junction leakage patterns where the relative position of poly gate to the junction edge was systematically varied, a problematic combination of process window and design rule was found and screened out of the actual circuit layout. This leakage component has to be considered to improve the refresh characteristics and stand-by current.