20 December 2022 in Theory and Building Practice
In this article on increasing the efficiency of steel combined structures, the tasks of rational design, regulation and control of structural parameters of elements, the use of steels with increased mechanical properties are considered. It is shown that for a six-span stiffening girder of a combined truss with elastic supports, which operates under a distributed load, the moment is 72 times smaller than the moment of a single-span beam. It is suggested to use high-strength steel for truss braces. Rationality criteria are proposed. On the basis of rationality criteria, new steel combined trusses were developed and their models were designed for stress tests. The results of experimental studies of models of combined trusses are presented. The results of experimental studies conducted on models of steel combined trusses qualitatively and quantitatively confirmed the theoretical results obtained on the basis of the proposed theory.
20 June 2022 in Theory and Building Practice
In this article, the rational constructive form of the combined steel truss with a span of 30 meters is received, with 59% fewer elements than the typical. Calculated regulation methods are offered stress-deformation state (SDS) combined steel trusses, which make it possible to increase their efficiency. Methods of estimated SDS regulation in combined steel trusses are given: change in the stiffness of the rodsand the creation of eccentricities in the nodes connecting the lattice to the upper belt and supporting eccentricities. Designs of experimental samples of rationally combined trusses are developed. Samples of rational steel combined trusses with a span of 3 meters with SDS adjustment are developedand a reference sample of a combined rational truss. A new method of testing combined trusses using a reference sample is proposed. An experimental plant for testing combined steel trusses has been designed, which allows you to test trusses with SDS rigs simultaneously.
20 June 2023 in Theory and Building Practice
In this article, a new method of increasing the efficiency of combined steel roof trusses is proposed and considered. A rational shape of the steel roof truss, including its topology and rational geometric parameters, was obtained, but without obtaining a rational SSS. A proposed method provides the adjustment of SSS in the truss by changing the upper belt panel length. On the basis of the obtained rational SSS of the combined truss, a new structural form is proposed. It is shown that thanks to the proposed method, it is possible to obtain a more efficient design by 18-32%, compared to typical ones. The diagram of the moments in the stiffness beam of the reference truss and the truss with SSS regulation is given. Further directions of research are determined, in particular, the development or improvement of rational structural forms and the use of calculation method of regulation of SSS in the stiffness beam of the steel combined truss.