Utilizing ionizing radiation for in situ studies in liquid media enables unique insights into nanostructure formation dynamics. As radiolysis interferes with observations, kinetic simulations are employed to understand and exploit beam‐liquid interactions. By introducing an intuitive tool to simulate arbitrary kinetic models for radiation chemistry, it is demonstrated that these models provide a holistic understanding of reaction mechanisms. This is shown for irradiated HAuCl4 solutions allowing for quantitative prediction and tailoring of redox processes in liquid‐phase transmission electron microscopy (LP‐TEM). Moreover, it is demonstrated that kinetic modeling of radiation chemistry is applicable to investigations utilizing X‐rays such as X‐ray diffraction (XRD). This emphasizes that beam‐sample interactions must be considered during XRD in liquid media and shows that reaction kinetics do not provide a threshold dose rate for gold nucleation relevant to LP‐TEM and XRD. Furthermore, it is unveiled that oxidative etching of gold nanoparticles depends on both, precursor concentration, and dose rate. This dependency is exploited to probe the electron beam‐induced shift in Gibbs free energy landscape by analyzing critical radii of gold nanoparticles.
1 January 2021 in Journal of the Electrochemical Society
With the aim to open a new window into corrosion processes this paper presents respirometric methods for real-time in situ monitoring of corrosion rates under immersion conditions. With these techniques, sensitive, non-destructive corrosion rate measurements are possible on basically all metals and alloys. Different methods are presented that enable to monitor HER, ORR or both reactions simultaneously based on the amount of evolved H2 or the amount of consumed O2 by volumetric, manometric and sensor-based approaches. Various research examples are presented, demonstrating the benefits and limitations of the different approaches. For Mg alloys, besides HER, ORR plays a role in the cathodic reactions and a good correlation of the total cathodic charge with mass loss was obtained. H2 dissolution into the electrolyte was identified as an important factor. The results obtained for Zn immersion corrosion in intermittent-flow and flow-through respirometric experiments suggest that the ORR mechanism leads to the generation of stable H2O2 under these conditions. As a result, the effective number of exchanged electrons for one O2 molecule was found to be in between two and four. The here introduced respirometric techniques allow new insights into corrosion mechanisms, in addition to enabling real-time monitoring of corrosion.
1 February 2019 in Materials Science and Engineering: C
A highly sensitive respirometric method is presented that allows real-time monitoring of reaction rates involving H2 and O2 during electrochemical polarization. The measurement approach is based on simultaneous monitoring of the changes in the total pressure and the O2 partial pressure inside a closed chamber. Hence, it is possible to quantify the rates resulting from reactions such as HER, ORR and OER as a function of the applied potential. As a result, deconvolution of the net electric current into cathodic and anodic partial reaction rates during electrochemical polarization can be obtained. It was demonstrated that the respirometric monitoring approach can reveal superfluous cathodic reactions from Al during cathodic polarization as well as during anodic polarization of Al and Mg AZ31. Thus, the true metal oxidation rate could be determined from the electric current and the cathodic reaction rates. Furthermore, the rate of the HER during cathodic electrodeposition of Zn was measured. Through respirometric monitoring of Ni and stainless steel at high anodic potentials, the rate of O2 evolution could be distinguished from electrode oxidation processes.