25 August 2016 in Advances in Materials Science and Engineering
So many soil improvement methods have been developed in order to increase bearing capacity of superstructure of the road to be constructed on the soft clayey road base soils, decrease settlements, and increase other strength specifications (CBR,,values, etc.). In this paper, lime stabilization of clayey road base soil with high water content and its improvement with geosynthetics (geocell + geotextile) reinforcement and comparisons of these two different improvement methods were made. For this purpose, plate loading experimental comparisons of clayey soil, which had high water content by 10% increasing the optimum water content, were made after it was improved with lime at the rates of 3, 6, and 12%, geotextile reinforcement, geocell reinforcement, geosynthetics reinforcement, and geosynthetics reinforcement + lime stabilization at various rates. It was understood that these improvement methods will not yield sufficient results on clayey soils with high water content on their own, and method of improvement with lime and then reinforcement with geosynthetics yields better results on these types of soils. Only one improvement state among ten different states examined in this study gave the sufficient results for the soil to be used for unpaved roads.
1 January 2016 in Advances in Materials Science and Engineering
Urban heat island (UHI) effect is built environmental issue related to pavements. It is desired to reduce pavement high surface temperature in summer to mitigate UHI effect. High surface temperature also affects slab temperature difference (the top surface temperature minus the bottom surface temperature of the slab). The increased slab temperature difference induces a high possibility of cracking in concrete roads. The prime aim of this study was to reduce the slab surface temperature by using recycled glass as a fine aggregate and zeolite as cement in concrete. Recycled glass was used to replace fine aggregate in proportions of 10%, 20%, and 30% by total weight of aggregate. Zeolite replaced Portland cement in proportions of 10% and 30% for three different proportions of recycled glass concrete mixtures. Optimum proportions were determined by examining mechanical properties of samples and alkali-silica reactions. It was noticed that using recycled glass and zeolite together in concrete reduces pavement surface temperature and temperature gradient in summer.
1 July 2024 in Turkish Journal of Civil Engineering
With sustainability being the most crucial issue of recent years, the use of waste materials in bitumen modification is increasing and becoming widespread. In this experimental study, it was aimed to investigate the high- and low-temperature behavior of bitumen samples modified with waste cooking oil (WCO), reactive ethylene terpolymer (RET), and polyphosphoric acid (PPA). Accordingly, the multiple stress creep and recovery (MSCR) test and the bending beam rheometer (BBR) test were conducted. Depending on the increasing WCO ratio, the Jnr,R%,∆T_c,and λ parameters of modified bitumens were examined in detail. It was observed that with increasing WCO ratio,the Jnr value increased, and elastic recovery and stiffness decreased. In addition, it has been determined that this composite-modified bitumen is resistant to heavy traffic loads and has sufficient flexibility at low temperatures.
1 January 2021 in Advances in Civil Engineering
In this study, lime stabilization and geocell reinforcement methods were investigated for a clayey subgrade of unpaved road at different water contents. This study is especially important in terms of determining the soil improvement method for road construction on wet lands. The effects of the geocell height (50, 100, 150, and 200 mm) and lime content (3, 6, and 12%) on the settlement of the subgrade soil at different water contents (25, 28, 30, 32, and 35%) were analyzed. Accordingly, a large scale plate loading test was designed, and it is utilized to achieve loading‐settlement curves. The bearing capacity and modulus of subgrade (k) of soil were determined. It was detected that the geocell height and lime content have different effects at different water contents, and the modulus of subgrade reaction became stable beyond a constant height of the geocell. It was understood that none of these two improvements did not meet the Highways Technical Specifications. It is detected that at least these two improvement techniques are needed to be applied together to meet the specifications for the soil examined in this study.
3 April 2025 in Road Materials and Pavement Design