30 July 2018 in Chemical Science
In this study, we, for the first time, report a high Cu solubility of 11.8% in single crystal SnSe microbelts synthesized via a facile solvothermal route. The pellets sintered from these heavily Cu-doped microbelts show a high power factor of 5.57 μW cm−1 K−2 and low thermal conductivity of 0.32 W m−1 K−1 at 823 K, contributing to a high peak ZT of ∼1.41. Through a combination of detailed structural and chemical characterizations, we found that with increasing the Cu doping level, the morphology of the synthesized Sn1−xCuxSe (x is from 0 to 0.118) transfers from rectangular microplate to microbelt. The high electrical transport performance comes from the obtained Cu+ doped state, and the intensive crystal imperfections such as dislocations, lattice distortions, and strains, play key roles in keeping low thermal conductivity. This study fills in the gaps of the existing knowledge concerning the doping mechanisms of Cu in SnSe systems, and provides a new strategy to achieve high thermoelectric performance in SnSe-based thermoelectric materials.
6 May 2020 in Energy & Environmental Science
Driven by materials science development, the thermoelectric performance has been enhanced. However, only increasing the figure of merit to enhance the thermoelectric efficiency becomes more challenging. Here, we combine an enhanced figure of merit and geometry optimization of a device by computer-aided design to achieve a record-high thermoelectric efficiency of 16%. A figure of merit over 2.2 in p-type Ge1−x−yCrxSbyTe alloys is achieved resulting from the convergence of three valence edges induced by Cr doping to enhance the power factor and superlattice precipitates to lower the thermal conductivity. Using finite element analysis simulations, we optimize the geometry of a segmented thermoelectric device made of the as-developed Ge1−x−yCrxSbyTe and other reported materials, leading to a record high efficiency. Furthermore, our simulations on over 70 existing n-type thermoelectric materials can serve as a library to bridge the gap between materials science and device engineering to achieve high-efficiency thermoelectric devices.
26 July 2017 in RSC Advances
Herein, electron beam-induced damage and recovery of a silicon thin film was investigated in situ via transmission electron microscopy (TEM). Via only controlling the electron beam flux, the damage and recovery processes could be controlled under electron beam irradiation at ambient temperature with an energy of 200 keV. Above the threshold value of the flux, the crystalline phase was transformed into an amorphous state, even formed a hole. The damage process became more pronounced with the increasing electron flux. Under this threshold value, the reverse process, including hole recovery and recrystallization, can be achieved. The effects of flux and the mechanisms regarding these phenomena have been proposed. This study can provide insights into the shaping of materials and control of their structure through high energy beam engineering.
2 March 2018 in Journal of Applied Physics
Semiconductors with one dimension on the micro-nanometer scale have many unique physical properties that are remarkably different from those of their bulk counterparts. Moreover, changes in the external field will further modulate the properties of the semiconductor micro-nanomaterials. In this study, we used focused ion beam technology to prepare freestanding ⟨111⟩-oriented GaAs sub-microwires from a GaAs substrate. The effects of laser irradiation and bending or buckling deformation induced by compression on the electrical transport properties of an individual GaAs sub-microwire were studied. The experimental results indicate that both laser irradiation and bending deformation can enhance their electrical transport properties, the laser irradiation resulted in a conductance enhancement of ∼30% compared to the result with no irradiation, and in addition, bending deformation changed the conductance by as much as ∼180% when the average strain was approximately 1%. The corresponding mechanisms are also discussed. This study provides beneficial insight into the fabrication of electronic and optoelectronic devices based on GaAs micro/nano-wires.