Sam Barber

Sam Barber

Auto-generated profile, based on publicly available information

Sam Barber

Lawrence Berkeley National Laboratory

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 September 2017 in Physical Review Letters
Verified
Journal Article
Open access
PDF file
SBS. K. Barber
S. K. Barber
JTJ. van Tilborg
J. van Tilborg
CSC. B. Schroeder
C. B. Schroeder
RLR. Lehe
R. Lehe
HTH.-E. Tsai
H.-E. Tsai
WLW. P. Leemans
W. P. Leemans
Single-shot, charge-dependent emittance measurements of electron beams generated by a laser plasma accelerator (LPA) reveal that shock-induced density down-ramp injection produces beams with normalized emittances a factor of 2 smaller than beams produced via ionization injection. Such a comparison is made possible by the tunable LPA setup, which allows electron beams with nearly identical central energy and peak spectral charge density to be produced using the two distinct injection mechanisms. Parametric measurements of this type are essential for the development of LPA-based applications which ultimately require high charge density and low emittance.

30 December 2014 in Physical Review Letters
Verified
Journal Article
Open access
PDF file
GAGerard Andonian
Gerard Andonian
OWOliver Williams
Oliver Williams
SBS. Barber
S. Barber
DBD. Bruhwiler
D. Bruhwiler
PFP. Favier
P. Favier
James RosenzweigJames Rosenzweig
James Rosenzweig
We report experimental measurements of narrow-band, single-mode excitation, and drive beam energy modulation, in a dielectric wakefield accelerating structure with planar geometry and Bragg-reflector boundaries. A short, relativistic electron beam (∼1  ps) with moderate charge (∼100  pC) is used to drive the wakefields in the structure. The fundamental mode of the structure is reinforced by constructive interference in the alternating dielectric layers at the boundary, and is characterized by the spectral analysis of the emitted coherent Cherenkov radiation signal. Data analysis shows a narrow-band peak at 210 GHz corresponding to the fundamental mode of the structure. Simulations in both 2D and 3D provide insight into the propagating fields and reproduction of the electron beams dynamics observables and emitted radiation characteristics.

1 June 2020 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
LFL. Fan-Chiang
L. Fan-Chiang
HMH.-S. Mao
H.-S. Mao
HTH.-E. Tsai
H.-E. Tsai
TOTobias Ostermayr
Tobias Ostermayr
KSK. K. Swanson
K. K. Swanson
WLW. P. Leemans
W. P. Leemans
Density transition injection is an effective technique for controllably loading electrons into a trapped phase for laser plasma accelerators. One common technique to achieve the required fluid structure is to impinge a thin blade on the plume of a supersonic nozzle. Density transitions induced in this way are often assumed to be bow shocks and therefore sharp, but simulations and fluorescence measurements presented in this work show that in many cases of interest, the density transition accessible to a laser propagating transverse to the shock is an intercepting shock, and therefore, shock thickness and density vary with pressure, laser height, and blade position. The fluid dynamics of a supersonic nozzle impinged on by a thin, flat object are explored through simulations and relevant features are verified via planar laser-induced fluorescence measurements. The implications of the results for tuning electron beam injectors in laser plasma accelerators are discussed.

8 June 2020 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
SBS. K. Barber
S. K. Barber
JBJianhui Bin
Jianhui Bin
AGA. J. Gonsalves
A. J. Gonsalves
FIF. Isono
F. Isono
JTJ. van Tilborg
J. van Tilborg
EEE. Esarey
E. Esarey
High-resolution (sub-%), single-shot energy distribution, and emittance measurements of GeV-class electron beams generated by laser plasma accelerators (LPAs) have been enabled through the use of an active plasma lens combined with relatively short dipole magnets. This setup, with only 60 cm between the LPA source and the final diagnostic screen, was facilitated through the use of a replenishable ∼20–40 nm thick liquid crystal plasma mirror to separate remnant laser radiation from the electron beam without emittance degradation. As LPAs capable of generating GeV-class electron beams at cm-scale distances become increasingly ubiquitous, there is a need to supplement these compact accelerators with equally compact diagnostics.

15 March 2023 in Physical Review Accelerators and Beams
Verified
Journal Article
Open access
PDF file
CBCurtis Berger
Curtis Berger
SBSam Barber
Sam Barber
FIFumika Isono
Fumika Isono
KJKyle Jensen
Kyle Jensen
JNJoseph Natal
Joseph Natal
JTJeroen van Tilborg
Jeroen van Tilborg
Laser plasma accelerators have the ability to produce high-quality electron beams in compact, all-optical-driven configurations, with the electron beams uniquely suited for a wide variety of accelerator-based applications. However, fluctuations and drifts in the laser delivery to the mm-scale plasma target (the electron beam source) will translate into electron beam source variations that can limit their utility for demanding applications like light sources. Based on previous work in developing a nonperturbative diagnostic for the high-power laser delivery at focus [1], we present a full four-dimensional active-stabilization system for the laser (transverse laser focus position and laser pointing angle in both transverse planes) and experimentally demonstrate how, as a result of the laser stabilization, critical parameters in the electron beam source were stabilized. Through the use of an energy resolved imaging system for the electron beam, we directly monitor the jitter in the transverse electron beam source location. Furthermore, the dispersion in the orthogonal plane to the magnetic spectrometer was recorded for each shot which is tied to the source pointing angle of the electron beam and, in part, driven by the angle of the laser at the interaction point. Our laser stabilization system reduced variation in the electron beam source location from ∼12 to 3  μm and reduced the dispersion jitter of the electron beam by 20%.

4 April 2018 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Closed access
PDF file
SBSamuel K. Barber
Samuel K. Barber
JTJeroen van Tilborg
Jeroen van Tilborg
CSCarl B Schroeder
Carl B Schroeder
RLRémi Lehe
Rémi Lehe
HTHai-En Tsai
Hai-En Tsai
WLWim P Leemans
Wim P Leemans
Laser plasma accelerators (LPA) offer an exciting possibility to deliver high energy, high brightness electrons beams in drastically smaller distance scales than is typical for conventional accelerators. As such, LPAs draw considerable attention as potential drivers for next generation light sources and for a compact linear collider. In order to asses the viability of an LPA source for a particular application, the brightness of the source should be properly characterized. In this paper, we present charge dependent transverse emittance measurements of LPA sources using both ionization injection and shock induced density down ramp injection, with the latter delivering smaller transverse emittances by a factor of two when controlling for charge density. The single shot emittance method is described in detail with a discussion on limitations related to second order transport effects. The direct role of space charge is explored through a series of simulations and found to be consistent with experimental observations.