Paolo Croce

Paolo Croce

Auto-generated profile, based on publicly available information

Paolo Croce

Department of Civil and Mechanical Engineering, University of Cassino and Southern Lazio, Cassino, Italy

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2016 in Journal of Geotechnical and Geoenvironmental Engineering
Verified
Journal Article
Closed access
GMGiuseppe Modoni
Giuseppe Modoni
AFAlessandro Flora
Alessandro Flora
SLStefania Lirer
Stefania Lirer
MOMaciej Ochmański
Maciej Ochmański
PCPaolo Croce
Paolo Croce
A methodology for cost-effective design of jet grouted water-sealing bottom plugs is presented in this paper. These massive barriers, made of partially overlapping jet grouted columns, are required to ensure temporary waterproofing to excavation areas and adequate uplift resistance against water loads. Therefore, the proposed calculation procedure simultaneously focuses on the structural performance and continuity of the plug. The design may be optimized by considering the possibility of reducing column length, performing injections only in the lower part of the plug, and leaving the upper part of the plug untreated. The reduction in column length may then result in a very slender slab, and a structural check has to be performed to avoid tension fracturing or overall structural collapse. Additionally, in spite of strict controls, jet grouted columns are never perfectly cylindrical or exactly aligned along their prescribed position, and thus the plug may present imperfections. Statistical evaluatio...

17 May 2024 in Acta Geotechnica
Verified
Journal Article
Open access
PDF file
RPRobeta Proia
Robeta Proia
SESalvatore Erminio
Salvatore Erminio
PCPaolo Croce
Paolo Croce
GMGiuseppe Modoni
Giuseppe Modoni
This paper illustrates the results of an experimental study on sand–bentonite mixtures for their use as confinement barriers for solid waste landfills. The mixtures have been prepared parametrically varying the percentage of bentonite. The sample preparation method was established willing to simulate the compaction processes on site. In fact, the compacted samples were tested following two different stress-wetting paths representative of the possible stress and imbibition sequences occurring on a landfill confinement barrier. In the first case, the barrier comes into contact with rainwater before being subjected to the overloading stress induced by waste disposal, while, in the second case, the barrier is overloaded by the waste before being wetted by the leachate. The compressibility and permeability of the sand–bentonite mixtures were determined, in both cases, by oedometric compression tests. The experimental results are analysed and compared in order to evaluate the influence of the bentonite content on the mechanical and hydraulic behaviour of the mixture. Interpretation of the results is also accomplished with a micro-mechanical investigation of the mixtures fabric. Suitable compositions of sand and bentonite are finally proposed for the design of effective confinement barriers.

6 July 2017
Verified
Conference Paper
Closed access
AFAlessandro Flora
Alessandro Flora
GMG. Modoni
G. Modoni
PCP. Croce
P. Croce
MSM. Siepi
M. Siepi
CKC. Kummerer
C. Kummerer
The paper merges the viewpoints of producers and researchers, illustrating the considerable potential offered by the latest technological innovations in jet grouting applications, associated to the most reliable analytical and numerical design methods. An overview of the European state of the art in terms of design and execution is presented, to show that the unavoidable defects of jet grouted structures may be taken into account to assess the structural performance and establish the tolerances for execution needed to properly manage uncertainty and reduce risks. It is argued that if such an approach will be fully considered both from the technical community and from the different standard codes (as it is going to happen in Europe with the new version of Eurocode 7), a flourishing future is in front of jet grouting, with an ever increasing ground improvement market share.