The low viscosity and the ability to control solidification rate make colloidal nanosilica grout an excellent ground-improvement solution which is functional for different engineering purposes. A comprehensive experimental programme was performed to test the effectiveness and applicability of low-pressure injection of aqueous nanosilica suspensions against seismic liquefaction and to provide the experimental basis for the design, execution, and control of treatments. Scanning electron microscope and X-ray diffraction tests carried out on samples prepared with variable dosages enabled analysis of the microstructure of the original material and grouted sand. The influence of the grout composition on the solidification rate, viscosity, and shear strength of the treated sand was evaluated with preliminary tests to optimize the use of material. The efficacy of treatment in terms of stress–strain response and liquefaction resistance was investigated with a series of drained monotonic and undrained cyclic triaxial tests. A quality control procedure based on sonic wave transmission was established by performing bender element tests on samples cured for different times. The intent was to find the trade-off between a cost-effective use of materials and the mechanical performance of the treated sand.
1 January 2024 in Journal of Geotechnical and Geoenvironmental Engineering
The response of granular soil upon cyclic loading and its many practical implications have been the subject of several past experimental and theoretical studies. However, the visual observation of samples reveals a complex pattern of inhomogeneous deformation that rises doubts on the classical phenomenological interpretation of laboratory tests. Aiming to understand the mechanisms activated by alternated compression and extension, a microscale analysis is herein performed. Small samples of dry Hostun sand subjected to cyclic tests are periodically scanned with x-ray tomograph during cyclic triaxial tests and the three-dimensional images are processed with the continuum Digital Image Correlation technique. The evolution of the strain field reveals yielding mechanisms activated during compression and extension with the activation, deactivation and reactivation of shear surfaces localized in different position of the sample and oriented along different directions
This paper illustrates the results of an experimental study on sand–bentonite mixtures for their use as confinement barriers for solid waste landfills. The mixtures have been prepared parametrically varying the percentage of bentonite. The sample preparation method was established willing to simulate the compaction processes on site. In fact, the compacted samples were tested following two different stress-wetting paths representative of the possible stress and imbibition sequences occurring on a landfill confinement barrier. In the first case, the barrier comes into contact with rainwater before being subjected to the overloading stress induced by waste disposal, while, in the second case, the barrier is overloaded by the waste before being wetted by the leachate. The compressibility and permeability of the sand–bentonite mixtures were determined, in both cases, by oedometric compression tests. The experimental results are analysed and compared in order to evaluate the influence of the bentonite content on the mechanical and hydraulic behaviour of the mixture. Interpretation of the results is also accomplished with a micro-mechanical investigation of the mixtures fabric. Suitable compositions of sand and bentonite are finally proposed for the design of effective confinement barriers.
Strain localisation influences the behaviour of sheared soils in a way that the assumption of the continuum loses validity and may become inapplicable. This occurrence affects the interpretation of triaxial tests where samples are usually considered as representative elements of an equivalent continuum and a phenomenological interpretation is carried out to calibrate constitutive models. Considering the inherent and stress-induced heterogeneity of the material as a possible precursor of localisation, the evolution of porosity and strain fields is studied interpreting with statistical and geostatistical analyses, the results of X-ray computerised microtomography. The study is performed on sandy samples sheared in triaxial compression and extension. The analysis carried out before shearing shows a meaningful statistical heterogeneity of the porosity with correlation lengths to the order of a few grain diameters. The evolution on shearing reveals the onset of a second statistical population and of an anisotropic spatial variation dictated by strain localisation.