5 November 2024 in IEEE Transactions on Industrial Electronics
A power factor correction (PFC) converter is essential for a switching mode power supply (SMPS), which is used in light-emitting diode televisions to comply with the harmonic current standard of IEC 61000-3-2 Class D. However, because of the high inductor peak current of a boost PFC converter, large-sized inductors and output electrolytic capacitors are employed. Consequently, the power density of the SMPS decreases, while the associated cost increases. This article presents a novel control method to minimize the inductor peak current in the widely used boost critical conduction mode PFC converters. The proposed scheme employs constant on-time control to satisfy the harmonic standard as well as peak current mode control to reduce the inductor current, thereby shaping the inductor current into a trapezoidal form. Thus, the proposed method reduces the size of the inductor and output electrolytic capacitors while satisfying the harmonic standards. The detailed analysis and comprehensive design procedures for the proposed method are presented. The effectiveness of the proposed approach has been verified using a 300W prototype.
2 September 2025 in IEEE Transactions on Power Electronics
A center-tapped rectifier is widely employed in applications requiring low output voltage and high output current. However, the rectifier diodes experience high voltage stresses, resulting in high conduction losses. To solve this problem, a low voltage-rated freewheeling diode was adopted in previous studies. It improves the overall efficiency by commutating the freewheeling current in the secondary side to the low voltage-rated diode instead of the high voltage-rated diodes. However, the detailed commutation process was not thoroughly explained in the previous studies. Actually, only a small portion of the total freewheeling current flows through a low voltage-rated diode, and most of it still flows through the high voltage-rated diodes, leading to slight improvement in efficiency. Therefore, this article offers the operation principle during the freewheeling interval in detail. Furthermore, it presents two simple methods for increasing the freewheeling current commutated to the low voltage-rated diode. These methods also reduce the circulating current in the primary side, resulting in low overall conduction losses. The article also explains the features and design considerations of each method and topological extensions for other types of rectifiers. Finally, a 250-W prototype is implemented, achieving a 94.8% peak efficiency.
5 December 2025 in IEEE Transactions on Industrial Electronics
This article proposes a new flyback-integrated phase-shift full-bridge (PSFB) converter to improve the overall efficiency of the conventional PSFB converters for applications requiring low output voltages and high output currents. It is implemented by replacing the output inductor with a coupled inductor and connecting its secondary side to the output in a flyback configuration. During the freewheeling period, the proposed converter transfers the energy stored in the coupled inductor to the output via the flyback circuit, consisting of only one coupled inductor winding and a low-voltage-rated diode. This provides the following main advantages: 1) elimination of the circulating current; 2) a lower forward voltage drop on the freewheeling diode; and 3) a reduced number of conducting components. Consequently, power losses on both the primary and secondary sides are significantly reduced. To validate the effectiveness of the proposed converter, a 300 W prototype was designed and tested. Experimental results confirmed an improvement in overall efficiency compared with the conventional converters, achieving 0.8% and 2.2% higher efficiency than the center-tapped rectifier and coupled inductor rectifier, respectively, under full-load conditions.