Muhammad Ashraful Alam

Muhammad Ashraful Alam

Auto-generated profile, based on publicly available information

Muhammad Ashraful Alam


Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 September 2022 in Science
Verified
Journal Article
Closed access
SSSiraj Sidhik
Siraj Sidhik
YWYafei Wang
Yafei Wang
MSMichael De Siena
Michael De Siena
RAReza Asadpour
Reza Asadpour
ATAndrew J. Torma
Andrew J. Torma
AMAditya D. Mohite
Aditya D. Mohite
Realizing solution-processed heterostructures is a long-enduring challenge in halide perovskites because of solvent incompatibilities that disrupt the underlying layer. By leveraging the solvent dielectric constant and Gutmann donor number, we could grow phase-pure two-dimensional (2D) halide perovskite stacks of the desired composition, thickness, and bandgap onto 3D perovskites without dissolving the underlying substrate. Characterization reveals a 3D–2D transition region of 20 nanometers mainly determined by the roughness of the bottom 3D layer. Thickness dependence of the 2D perovskite layer reveals the anticipated trends for n-i-p and p-i-n architectures, which is consistent with band alignment and carrier transport limits for 2D perovskites. We measured a photovoltaic efficiency of 24.5%, with exceptional stability ofT99(time required to preserve 99% of initial photovoltaic efficiency) of >2000 hours, implying that the 3D/2D bilayer inherits the intrinsic durability of 2D perovskite without compromising efficiency.

17 December 2014 in Scientific Reports
Verified
Journal Article
Open access
JLJoonhyung Lee
Joonhyung Lee
PDPiyush Dak
Piyush Dak
YLYeonsung Lee
Yeonsung Lee
HPHeekyeong Park
Heekyeong Park
WCWoong Choi
Woong Choi
SKSunkook Kim
Sunkook Kim
We present a MoS2 biosensor to electrically detect prostate specific antigen (PSA) in a highly sensitive and label-free manner. Unlike previous MoS2-FET-based biosensors, the device configuration of our biosensors does not require a dielectric layer such as HfO2 due to the hydrophobicity of MoS2. Such an oxide-free operation improves sensitivity and simplifies sensor design. For a quantitative and selective detection of PSA antigen, anti-PSA antibody was immobilized on the sensor surface. Then, introduction of PSA antigen, into the anti-PSA immobilized sensor surface resulted in a lable-free immunoassary format. Measured off-state current of the device showed a significant decrease as the applied PSA concentration was increased. The minimum detectable concentration of PSA is 1 pg/mL, which is several orders of magnitude below the clinical cut-off level of ~4 ng/mL. In addition, we also provide a systematic theoretical analysis of the sensor platform – including the charge state of protein at the specific pH level and self-consistent channel transport. Taken together, the experimental demonstration and the theoretical framework provide a comprehensive description of the performance potential of dielectric-free MoS2-based biosensor technology.

4 March 2019 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MAMuhammad A. Alam
Muhammad A. Alam
MSMengwei Si
Mengwei Si
PYPeide D. Ye
Peide D. Ye

14 June 2024 in Science
Verified
Journal Article
Closed access
SSSiraj Sidhik
Siraj Sidhik
IMIsaac Metcalf
Isaac Metcalf
WLWenbin Li
Wenbin Li
TKTim Kodalle
Tim Kodalle
CDConnor J. Dolan
Connor J. Dolan
AMAditya D. Mohite
Aditya D. Mohite
We present a design strategy for fabricating ultrastable phase-pure films of formamidinium lead iodide (FAPbI 3 ) by lattice templating using specific two-dimensional (2D) perovskites with FA as the cage cation. When a pure FAPbI 3 precursor solution is brought in contact with the 2D perovskite, the black phase forms preferentially at 100°C, much lower than the standard FAPbI 3 annealing temperature of 150°C. X-ray diffraction and optical spectroscopy suggest that the resulting FAPbI 3 film compresses slightly to acquire the (011) interplanar distances of the 2D perovskite seed. The 2D-templated bulk FAPbI 3 films exhibited an efficiency of 24.1% in a p-i-n architecture with 0.5–square centimeter active area and an exceptional durability, retaining 97% of their initial efficiency after 1000 hours under 85°C and maximum power point tracking.

15 December 2010 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
SDS. Dongaonkar
S. Dongaonkar
JSJ. D. Servaites
J. D. Servaites
GFG. M. Ford
G. M. Ford
SLS. Loser
S. Loser
JMJ. Moore
J. Moore
MAM. A. Alam
M. A. Alam
We compare the dark current-voltage (IV) characteristics of three different thin-film solar cell types: hydrogenated amorphous silicon (a-Si:H) p-i-n cells, organic bulk heterojunction (BHJ) cells, and Cu(In,Ga)Se2 (CIGS) cells. All three device types exhibit a significant shunt leakage current at low forward bias (V<∼0.4) and reverse bias, which cannot be explained by the classical solar cell diode model. This parasitic shunt current exhibits non-Ohmic behavior, as opposed to the traditional constant shunt resistance model for photovoltaics. We show here that this shunt leakage (Ish) , across all three solar cell types considered, is characterized by the following common phenomenological features: (a) voltage symmetry about V=0 , (b) nonlinear (power law) voltage dependence, and (c) extremely weak temperature dependence. Based on this analysis, we provide a simple method of subtracting this shunt current component from the measured data and discuss its implications on dark IV parameter extraction. We propose a space charge limited (SCL) current model for capturing all these features of the shunt leakage in a consistent framework and discuss possible physical origin of the parasitic paths responsible for this shunt current mechanism.

11 June 2021 in Nature Communications
Verified
Journal Article
Open access
PDF file
SHSeongin Hong
Seongin Hong
NZNicolò Zagni
Nicolò Zagni
SCSooho Choo
Sooho Choo
NLNa Liu
Na Liu
SBSeungho Baek
Seungho Baek
SKSunkook Kim
Sunkook Kim
Various large-area growth methods for two-dimensional transition metal dichalcogenides have been developed recently for future electronic and photonic applications. However, they have not yet been employed for synthesizing active pixel image sensors. Here, we report on an active pixel image sensor array with a bilayer MoS2 film prepared via a two-step large-area growth method. The active pixel of image sensor is composed of 2D MoS2 switching transistors and 2D MoS2 phototransistors. The maximum photoresponsivity (Rph) of the bilayer MoS2 phototransistors in an 8 × 8 active pixel image sensor array is statistically measured as high as 119.16 A W−1. With the aid of computational modeling, we find that the main mechanism for the high Rph of the bilayer MoS2 phototransistor is a photo-gating effect by the holes trapped at subgap states. The image-sensing characteristics of the bilayer MoS2 active pixel image sensor array are successfully investigated using light stencil projection.