In this paper, the stamp forming process of a U-shaped cross-section channel with sharp corners of composite laminates including aluminum sheet and polyvinyl chloride (PVC) reinforced with 3D-fiberglass was investigated. The laminates were produced by manual layup and arrangement of fibers with different angles of [0°/90°] and [± 45°] degrees using hot press. The process of forming composite samples was carried out at temperatures of 25, 80, 120, 160°C and different velocities of punch. The effect of parameters including layup configuration, temperature, and forming speed on the spring-back of the formed laminates and the required forming force were evaluated. The results showed that as the forming temperature increased, the forming force decreased sharply. The lowest forming force was obtained for the laminate with [± 45°, Al, ± 45°] layout at 160°C temperature which was equal to 0.7KN. Also, with the increase in temperature, the spring-back angle has been reduced, the lowest of which is obtained with the laminate with [0°/90°] 3 layout equal to 8 degrees. Finally, it was concluded that increasing the speed of the forming process results in a decrease in the spring-back angle and this effect is more pronounced at higher temperatures. Graphical abstract
2 July 2020 in Transactions of the Indian Institute of Metals
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross section. Finite element simulation of the hot gas forming process is carried out to investigate the effects of process parameters including time period of forming process, temperature, and loading path. Uniaxial tensile tests under various temperatures and strain rates is performed, in order to obtain flow stress curves of the material. Corner radius and thickness distribution of tubular formed parts is investigated. The results show smaller corner radii could be formed at higher temperatures, whereas lower forming pressure is necessary. Increasing the time period of the process enhances the corners of the specimens to be formed. In addition, the maximum of formability is obtained when the gas pressure increases rapidly at the beginning of the process. However, the increasing rate of gas pressure must be reduced to form a smaller corner radius.