Key Laboratory of Advanced Micro-Structured Materials MOE, Institute of Precision Optical Engineering, School of Physics Science and Engineering, Tongji University, Shanghai 200092, China
Auto-generated profile, based on publicly available information
Jinshuai Zhang
Key Laboratory of Advanced Micro-Structured Materials MOE, Institute of Precision Optical Engineering, School of Physics Science and Engineering, Tongji University, Shanghai 200092, China
Hybrid organic–inorganic perovskites have generated considerable research interest in the field of optoelectronic devices. However, there have been significantly fewer reports of their thermoelectric properties despite some promising early results. In this article, we investigate the thermoelectric properties of bismuth-doped CH3NH3PbBr3 (MAPbBr3) single crystals. The high-quality Bi-doped crystals were synthesized by inverse temperature crystallization and it was found that Bi substitutes onto the B-site of the ABX3 perovskite lattice of MAPbBr3 crystals with very little distortion of the crystal structure. Bi doping does not significantly alter the thermal conductivity but dramatically enhances the electrical conductivity of MAPbBr3, increasing the charge carrier density by more than three orders of magnitude. We obtained a negative Seebeck coefficient of −378 μV K−1 for 15% (x = 0.15) Bi-doped MAPb(1−x)BixBr3 confirming n-type doping and also measured the figure of merit, ZT. This work highlights routes towards controlled substitutional doping of halide perovskites to optimise them for thermoelectric applications.
Reactive sputtering with a mixture of argon and nitrogen (N2 partial pressure of 4%, 8%, and 15%) as the working gas is used to develop the high reflectance Pd/B4C multilayers for soft X-ray region application. Compared to the pure Ar fabricated sample, the interface roughness of the nitridated multilayer is slightly increased while the compressive stress is essentially relaxed from -623 MPa (pure Ar) to -85 MPa (15% N2). A maximum reflectance of 32% is measured at the wavelength of 9.5 nm for the multilayer fabricated with 15% N2. After storing the multilayers in an air environment for 6–17 months, a distinct aging effect is observed on the nitridated samples. The transmission electron microscopy results indicate that a large part of the top layers of the nitridated samples is deteriorated with severe interdiffusion, essential decrease in d-spacing, and compacted multilayer structure. The deterioration is less pronounced for the multilayers fabricated with a higher ratio of N2. Energy dispersive X-ray spectroscopy reveals that the concentration of nitrogen and boron in the degraded area is much reduced compared to the intact layers. A primitive model of upward diffusion of nitrogen and boron is proposed to explain the aging effects of the nitridated structure.
Low stress W/Si multilayer mirrors are demanded in the hard X-ray telescopes to achieve the high angular resolution. To reduce the stress of the as-deposited multilayer and maintain a high reflectivity, two groups of low-temperature annealing experiments were performed on the periodic multilayers with a d-spacing of ~3.8 nm. The temperature-dependent experiments show that the 150 °C annealing can slightly increase the reflectivity while the stress reduced only by 24%. Higher temperature annealing induced a larger reduction of the stress and the multilayer reached an almost zero stress state at 250 °C. The stress relaxation was accompanied by a small drop of reflectivity of ≤5% and a period compaction of <0.02 nm. The time-dependent experiments indicate that most of the stress changes occurred within the first 10 minutes while a prolonged annealing is not useful. The X-ray scattering and transmission electron microscopy were further used to study the microstructure changes of the multilayers. It is found that the W/Si multilayer exhibits an amorphous structure before and after annealing, while an enhanced diffusion and intermixing is the main reason for the stress relaxation and structure changes.