This work combines experimental and theoretical approaches to examine how the length of an alkyl linker can be used to tune the electrochemical, optical, and device-related electrical properties of carbazolylalkyl-substituted polydithienopyrrole polymers (pCxDTP). Using a scalable four-step synthetic route, a series of monomers with systematically varied alkyl spacers was prepared and subsequently electropolymerized directly onto conductive substrates, yielding uniform polymer films suitable for device integration. The polymer band gap ranges from to 2.4 for pC3DTP to 2.0 eV for pC12DTP. This trend arises from the concurrent increase of the HOMO and lowering of the LUMO levels, with both effects depending on the alkyl chain length. Sandwich devices with an ITO | pCxDTP | Al architecture show reproducible memristive behavior, characterized by pinched hysteresis loops and pronounced frequency dependence. Longer alkyl linkers result in a more pronounced hysteresis in current-voltage already at higher sweep rates, revealing a clear relationship between molecular structure and device performance. Density functional theory and time-dependent DFT calculations are consistent with the experimental findings and indicate that alkyl linker length subtly influences frontier orbital energies, ionization potentials, and charge delocalization. Oligomer-level modeling further accounts for the observed band gap narrowing and spectral broadening through increased conjugation length and chain dispersity. Overall, these results highlight alkyl linker engineering as a practical strategy for optimizing conjugated polymers for electrochromic and memristive applications.
This study investigates the rheological and tribological properties of magnetorheological fluids (MRFs) based on carbonyl iron particles (CIPs). The effects of particle size, using CN and ES grades, and polymer surface modification with poly(trimethylsilyloxyethyl methacrylate) (PHEMATMS) grafted onto CN particles by surface-initiated atom transfer radical polymerization were evaluated. The prepared CI-PHEMATMS particles exhibited a controlled polymer layer with Mn = 14,000 g mol⁻¹ and Đ = 1.29, while maintaining a high magnetic response, with the total magnetization decreasing by only 2.4% compared with neat CN particles. Tribological tests were performed under reciprocating steel ball-on-plate contact, both with and without an external magnetic field. The magnetic field increased the coefficient of friction (COF) in all systems due to field-induced particle chaining. However, PHEMATMS-coated CIPs showed the lowest COF under magnetic conditions and a gradual COF decrease without the field. Surface analysis revealed the lowest roughness for specimens tested with CI-PHEMATMS under non-magnetic conditions (Ra = 0.19 µm), compared with CN (Ra = 0.35 µm) and ES particles (Ra = 0.23 µm). In addition, surface texturing of the steel counterface was studied as a complementary approach to modify the sliding interface and improve local MRF retention. Energy-dispersive X-ray analysis confirmed Si-containing residues within the wear track, suggesting retention of PHEMATMS-derived material in the contact zone. These results indicate that PHEMATMS modification, combined with controlled surface topography, can improve the tribological stability of MRFs.