25 July 2023 in IEEE Transactions on Power Electronics
Carrier-based discontinuous pulse width modulation (CB-DPWM) is widely used in three-level AC/DC converters due to its features of higher efficiency and simpler implementation. However, the problems of switching losses, current distortion around zero-crossing points, and neutral point (NP) voltage fluctuation are mutually coupled for the Vienna rectifier. Therefore, this article proposes a modified carrier-based discontinuous pulse width modulation (MCB-DPWM) scheme for the Vienna rectifier with improved zero-sequence voltage injection. The clamping range and clamping mode that suppress zero-crossing distortion are adjusted. Compared to continuous PWM and conventional discontinuous PWM (DPWM), the proposed MCB-DPWM could effectively eliminate zero-crossing distortion and reduce the NP voltage fluctuation and switching loss, which means higher input current quality and efficiency. Moreover, it features a simpler implementation and less computational burden than space-vector-based PWM. Therefore, it is more suitable for high frequency applications. Finally, the simulation and experiment results demonstrate the proposed MCB-DPWM could reduce switching loss and current distortion with lower NP voltage fluctuation under different modulation indices.
9 October 2023 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Discontinuous pulse width modulation (DPWM) is widely used in three-level AC/DC converters due to its higher efficiency. For dual-output load applications, the vector synthesis error caused by the unbalanced NP voltage results in severe input current distortion with conventional DPWM. Moreover, the computational burden is further aggravated by the complicated subsector identification and dwelling time calculation resulting from partial vector redistribution after considering unbalanced NP voltage. In this article, modified subsector division and clamping modes are analyzed to eliminate vector synthesis errors. Then, an optimized carrier-based discontinuous pulse width modulation (OCB-DPWM) scheme with simple zero-sequence components (ZSCs) injection is proposed. Thus, the input current distortion under unbalanced NP voltages can be effectively suppressed. Compared with the modulation method with adjusting the NP voltage, which results in additional switching operations, the switching loss can be effectively reduced. In addition, the calculation of the ZSCs is extremely simple, and the program execution time is reduced by more than 60% compared with the existing modulation method. Finally, the simulation and experimental results of the Vienna rectifier are presented to validate the performance in terms of improved current THD and switching loss with different load conditions.