1 July 2011 in Microelectronic Engineering
16 May 2016 in Scientific Reports
Filament-type HfO2-based RRAM has been considered as one of the most promising candidates for future non-volatile memories. Further improvement of the stability, particularly at the “OFF” state, of such devices is mainly hindered by resistance variation induced by the uncontrolled oxygen vacancies distribution and filament growth in HfO2films. We report highly stable endurance of TiN/Ti/HfO2/Si-tip RRAM devices using a CMOS compatible nanotip method. Simulations indicate that the nanotip bottom electrode provides a local confinement for the electrical field and ionic current density; thus a nano-confinement for the oxygen vacancy distribution and nano-filament location is created by this approach. Conductive atomic force microscopy measurements confirm that the filaments form only on the nanotip region. Resistance switching by using pulses shows highly stable endurance for both ON and OFF modes, thanks to the geometric confinement of the conductive path and filament only above the nanotip. This nano-engineering approach opens a new pathway to realize forming-free RRAM devices with improved stability and reliability.
20 September 2012 in The Journal of Physical Chemistry C
1 February 2017 in Review of Scientific Instruments
In this paper, we propose a new procedure which aims at measuring the polarisation switching current at the nanoscale on ferroelectric thin films with the atomic force microscope tip used as a top electrode. Our technique is an adaptation of the so-called positive up negative down method commonly operated on large electrodes. The main obstacle that must be overcome to implement such measurement is the enhancement of the signal to noise ratio, in a context where the stray capacitance of the sample/tip/lever/lever holder system generates a dielectric displacement current several orders of magnitude higher than the current to be measured. This problem is solved by the subtraction of the displacement current through a reference capacitance. For the first time, we show an example of nanoscale positive up negative down measurement of the polarisation charge on a PbZrTiO3 thin film and compare the measured value with paraelectric samples. From the comparison with macroscopic measurement, we deduce the effective area of contact between the tip and the sample.
15 May 2012 in Journal of Applied Physics
We report the electrical properties, measured both at the macroscopic and nanometric scales, of epitaxial (110)-Na0.5Bi0.5TiO3 (NBT) thin films grown on (110)Pt/(110)SrTiO3 by pulsed laser deposition (PLD). The influence of the A-site composition (Na and/or Bi excess) on both the structural/microstructural characteristics and the electrical properties is discussed. Whatever the composition of the NBT target, the final layers are systematically epitaxially grown, with NBT crystallites mainly (110)-oriented, and as well (100)-oriented for some minor proportion. Atomic force microscopy (AFM) images reveal the coexistence of two kinds of grains presenting different shapes: namely flat and elongated grains, corresponding to (100)- and (110)-oriented NBT crystallites, respectively. The macroscopic ferroelectric properties were measured at room temperature. A rather well-defined shape of the hysteresis loops was obtained: the incorporation of a Bi excess in the target clearly improves the saturation of the loops. The ferroelectric performances are a remanent polarization (Pr) value, ranging from 7 to 14 μC/cm2, associated with a coercive field (Ec) in the range 68–85 kV/cm. In addition, at 105 Hz, the relative permittivity was about ɛr ∼ 255–410 and the dielectric losses (tan δ) were ∼6%–7%. Finally, the electrical properties at the local scale were investigated by coupling piezoresponse force microscopy (PFM) and tunneling AFM (TUNA) measurements. The collected data reveal that the two types of grains behave differently. The PFM amplitude signal of (110)-oriented grains is very contrasted and such grains are often divided in ferroelectric bi-domains of nanometric sizes, whereas the response of (100)-oriented grains is less contrasted and more homogeneous. The interpretation of the PFM signal is provided. The piezoloop recorded on a (110)NBT grain is strongly distorted and shifted along the vertical axis, in agreement with the vertical drift observed for macroscopic ferroelectric data. Finally, TUNA data clearly indicate that flat grains are leakier than elongated grains, highlighting the anisotropy of the electrical properties at the local scale.
1 November 2001 in Journal of Non-Crystalline Solids