Zoltán Meiszterics

Zoltán Meiszterics

Auto-generated profile, based on publicly available information

Zoltán Meiszterics

Department of Mechanical Engineering, Faculty of Engineering and Information Technology, University of Pécs, Pécs, Hungary

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 November 2024 in Energies
Verified
Journal Article
Open access
PDF file
LBLászló Budulski
László Budulski
Gábor LochGábor Loch
Gábor Loch
LLLenkovics Lenkovics
Lenkovics Lenkovics
MBMihály Baumann
Mihály Baumann
Balázs CakóBalázs Cakó
Balázs Cakó
Dávid CsonkaDávid Csonka
Dávid Csonka
This paper describes experiments on finned tube heat exchangers, focusing on reducing the thermal contact resistance at the contact between the pipe and the lamella. Various contact materials, such as solders and adhesives, were investigated. Several methods of establishing contact were tested, including blowtorch soldering, brazing, and furnace soldering. Thermal camera measurements were carried out to assess the performance of the contact materials. Moreover, finite element analysis was performed to evaluate the contact materials and establish guidelines in the fin–tube connection modeling by comparing simplified models with the realistic model. Blowtorch brazing tests were successful while soldering attempts failed. During the thermographic measurements, reflective surfaces could be measured after applying a thin layer of paint with high emissivity. These measurements did not provide valuable results; thus, the contact materials were assessed using a finite element analysis. The results from the finite element analysis showed that all the inspected contact materials provided better heat transfer than not using a contact material. The heat transfer rate of the tight-fit realistic model was found to be 33.65 for air and 34.9 for the Zn-22Al contact material. This finding could be utilized in developing heat exchangers with higher heat transfer with the same size.

10 March 2026 in Pollack Periodica
Verified
Journal Article
Open access
ZMZoltán Meiszterics
Zoltán Meiszterics
GVGyula Ferenc Vasvári
Gyula Ferenc Vasvári
DCDávid Csonka
Dávid Csonka
TZTamás Zsebe
Tamás Zsebe
LNLívia Nagy
Lívia Nagy
GNGéza Nagy
Géza Nagy
The aim of the studies was to investigate the corrosion behavior of an aluminum alloy AlMg4.5Mn0.7 produced by an additive technology based on cold metal transfer technology. The tests were performed by conventional electrochemical methods. Open circuit potential, time measurements were used to measure the corrosion potential values and its change in time during exposition to corroding media. Cyclic potentio-dynamic polarization curves were used to investigate the susceptibility to pitting corrosion. Significant differences could be detected between the corrosion behavior of the alloy of same composition prepared with conventional technology and with cold metal transfer one. The investigations clearly indicate different stages of sensitization and susceptibility to pitting corrosion.

1 January 2022 in Magyar Kémiai Folyóirat
Verified
Journal Article
Open access
ZMZoltán Meiszterics
Zoltán Meiszterics
AKAndrás Kiss
András Kiss
DFDániel Filotás
Dániel Filotás
AAAbdelilah Asserghine
Abdelilah Asserghine
Livia Naszályi NagyLivia Naszályi Nagy
Livia Naszályi Nagy
GNGéza Nagy
Géza Nagy