Bruno Wanderley França

Bruno Wanderley França

Auto-generated profile, based on publicly available information

Bruno Wanderley França

Núcleo de Inovação Tecnológica em Engenharia Elétrica, NITEE, Universidade Federal Fluminense, Niterói 24210-240, RJ, Brazil

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 August 2014 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
BFBruno W. Franca
Bruno W. Franca
LSLeonardo F. da Silva
Leonardo F. da Silva
MAMaynara A. Aredes
Maynara A. Aredes
MAMAURICIO AREDES
MAURICIO AREDES
This paper presents an improved controller for the dual topology of the unified power quality conditioner (iUPQC) extending its applicability in power-quality compensation, as well as in microgrid applications. By using this controller, beyond the conventional UPQC power quality features, including voltage sag/swell compensation, the iUPQC will also provide reactive power support to regulate not only the load-bus voltage but also the voltage at the grid-side bus. In other words, the iUPQC will work as a static synchronous compensator (STATCOM) at the grid side, while providing also the conventional UPQC compensations at the load or microgrid side. Experimental results are provided to verify the new functionality of the equipment.

7 October 2022 in International Transactions on Electrical Energy Systems
Verified
Journal Article
Open access
PDF file
MSMohammad Hosein Sabzalian
Mohammad Hosein Sabzalian
SPSasan Pirouzi
Sasan Pirouzi
MAMAURICIO AREDES
MAURICIO AREDES
BFBruno Wanderley Franca
Bruno Wanderley Franca
ACAna Carolina Cunha
Ana Carolina Cunha
With the advent of smart grid theory, distribution networks can include different microgrids (MGs). Therefore, to achieve the desired technical and economic objectives in these networks, there is a need for bilateral coordination between their operators. In the following, by defining an energy management problem for them, it is predicted that the mentioned goals can be achieved. Therefore, this paper presents the hybrid flexible-securable operation (HFSO) of a smart distribution network (SDN) with grid-connected multi-microgrids using a two-layer coordinated energy management strategy. In the first layer, the microgrid (MG) operator is coordinated with sources, storages, and demand response operators. This layer models the HFSO method in the grid-connected MGs, which is based on minimizing the difference between the sum of operating cost of nonrenewable distributed generations and cost of energy received from the SDN, and the sum of flexibility and security benefits. It is constrained to AC optimal power flow, flexibility and voltage security constraints, operation model of sources and storages, and demand response. The second layer concerns coordination between the MG operators and the SDN operator. Its formulation is the same as that of the first layer, except that the HFSO model is used in the SDN according to MGs power daily data obtained from the first layer problem. The strategy converts the mixed-integer nonlinear programming to linear one to obtain the optimal solution with low calculation time and error. Moreover, stochastic programming models the uncertainties of load, energy price, and renewable power. Eventually, numerical results confirm the capability of the scheme to improve technical and economic indices simultaneously. As a result, by expecting the optimal operation for sources, storage, and responsive loads, it succeeded to enhance energy loss, voltage profile, and voltage security of the mentioned networks by up to 30%, 22%, and 5%, respectively, compared to power flow studies. In addition, there was enhancement in economic and flexibility status of the SDN and MGs.

14 October 2019 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
Gustavo GontijoGustavo Gontijo
Gustavo Gontijo
Thiago Cardoso TricaricoThiago Cardoso Tricarico
Thiago Cardoso Tricarico
LSLeonardo Francisco da Silva
Leonardo Francisco da Silva
DKDaniel Krejci
Daniel Krejci
BFBruno Wanderley Franca
Bruno Wanderley Franca
Josep M. GuerreroJosep M. Guerrero
Josep M. Guerrero
This article presents the modeling and experimental validation of a recently presented DFIG wind power system driven by a two-level three-phase converter in which the grid-side converter is connected in series with the grid. The series-grid-side converter is able to compensate for stator-voltage sags, unbalance and harmonic distortion resulting in a high-power-quality system with considerable low-voltage-ride-through capability. The proposed control technique makes it feasible to obtain such high-power-quality system using a conventional two-level three-phase converter composed of 12 IGBTs, with no need of extra switches, while maintaining the usual high efficiency and low cost inherent to the DFIG configuration. Moreover, using the proposed linear model, one can design the dc-link-voltage controller's parameters according to the desired dynamic behavior. Experimental results are presented using a 15 kW test bench, which validate the proposed control technique.

3 September 2018 in IEEE Transactions on Sustainable Energy
Verified
Journal Article
Closed access
Gustavo GontijoGustavo Gontijo
Gustavo Gontijo
Thiago Cardoso TricaricoThiago Cardoso Tricarico
Thiago Cardoso Tricarico
BFBruno Wanderley Franca
Bruno Wanderley Franca
LSLeonardo Francisco da Silva
Leonardo Francisco da Silva
Emanuel Leonardus van EmmerikEmanuel Leonardus van Emmerik
Emanuel Leonardus van Emmerik
MAMAURICIO AREDES
MAURICIO AREDES
The DFIG has been widely used in the wind power industry due to its technical advantages. However, current researches are being developed aiming at overcoming some of its drawbacks concerning reliability, efficiency and power quality. Since the wind farms are usually located at remote places, connected to weak grids, high reliability is required and some power quality issues deserve attention. This paper proposes a low-complexity, robust control of a DFIG driven by a direct matrix converter based on a model predictive rotor current control. The matrix converter is interesting due to the absence of the bulky and sensitive dc-link capacitors, leading to higher reliability. The predictive control is used to perform speed regulation. Moreover, this combination of converter and straightforward control is proven to be a robust technique that naturally compensates for stator current issues, which arises due to a low-power-quality grid voltage. Besides, a linear model of the proposed system is presented in order to be possible to use the linear-control-theory tools to execute the system control design. A processor-in-the-loop simulation is employed to validate the proposed control.

27 August 2024 in IEEE Internet of Things Journal
Verified
Journal Article
Closed access
CMCarolina Menezes
Carolina Menezes
BFBruno França
Bruno França
YLYona Lopes
Yona Lopes
With the accelerating digitalization of power systems, technologies like the Metaverse (MV), Digital Twins (DTs), and Extended Reality (XR) present new opportunities to optimize decision-making processes in the energy sector. However, Research and Development (R&D) in this area is challenging due to its multidisciplinary nature and the blurred boundaries between these concepts. Given this scenario, this article surveys the literature over the period 2010–2023 on the MV, DTs, and XR within the context of the energy sector, investigating how these technologies can address the current challenges of this sector. To achieve that, five application fields were identified, namely 1) energy market and demand management; 2) training and occupational safety; 3) performance and real-time control; 4) maintenance and inspection; and 5) project planning. The most recommended technology for each application field was also identified. Moreover, the development tools and technical challenges of the reviewed studies were mapped to provide a broader view of current implementation approaches and literature gaps. Finally, this review also provides directions for future research and a map of requirements for the widespread adoption of these technologies in power systems.

10 August 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
BFBruno Wanderley Franca
Bruno Wanderley Franca
MAMAURICIO AREDES
MAURICIO AREDES
LSLeonardo F. da Silva
Leonardo F. da Silva
Gustavo GontijoGustavo Gontijo
Gustavo Gontijo
Thiago Cardoso TricaricoThiago Cardoso Tricarico
Thiago Cardoso Tricarico
JCJohnny Posada Contreras
Johnny Posada Contreras
This article proposes a shunt active filter (SAF) operating as a Synchronverter to enhance its performance, including the virtual inertia functionality. The SAF behaves as a voltage source with a low-impedance path for harmonic contents. Synchronverter behavior is used together with selective filtering through proportional-resonant controllers to provide selective harmonic filtering of the load current, selective harmonic blocking of the source current, and low-impedance path for nonselected harmonic contents from the load and the source currents. The virtual inertia functionality aims to contribute to frequency stability during power system transients. Besides filtering unbalanced and harmonic contents and compensating for reactive power, the SAF contributes to inertia response during frequency transients. A tuning design method is proposed to ensure stability and proper conditioning of the power-quality issues. The reduced quantity of parameters to be tuned is another advantage of the proposed controller. Simulation and experimental results validate the compensation performance of the SAF.