In this paper, micellar-mediated synthesis of chalcones was explored. After optimization of the reaction conditions, the cationic surfactant CTAB and the nonionic one, Tween 80, were taken into consideration. Both surfactants were used to study the scope of Claisen-Schmidt reactants, and a wide scope on both aromatic aldehydes and methyl ketones was explored, obtaining from good to very good yields in most cases and thus demonstrating that the chalcones can be proficiently synthesized in micellar solutions with a wide functional group tolerability. Often, when one surfactant did not perform well, the other surfactant performed better, demonstrating that the use of different surfactants can constitute a good alternative to overcome reactivity problems. Besides, Tween 80 can be proposed as a good and greener alternative to CTAB in most cases. Some reactions gave low yields, showing that some specific improvements would be needed to address the low reactivity. The micellar medium was studied by NMR to search for information about the association of the Claisen-Schmidt reactants with the micelles and their locations within them. Diffusion Ordered Spectroscopy (DOSY) was applied to assess the interaction and the percentage of incorporation of reactants into the micelles.
In this work, sustainable Li‐based battery separators are prepared starting from a waste material from the glass industry, viz . polyvinyl butyral (PVB) widely used as a sacrificial interlayer in high impact‐resistant windows. First, polymeric membranes are prepared via the phase‐inversion method using commercial PVB as the backbone and 4,4′‐methylenebis(cyclohexylisocyanate) as a crosslinking agent. They are characterized from a physicochemical viewpoint by thermomechanical analysis, infrared spectroscopy, and scanning electron microscopy, and are successfully tested as separators in Li‐metal cells with LP30 electrolyte. Electrical and electrochemical properties are evaluated by impedance spectroscopy and galvanostatic cycling, providing comparable results with commercial Celgard 25 µm monolayer microporous polypropylene separator. As a proof‐of‐concept, for the first time, recycled PVB‐based polymer membranes from wasted car glasses are prepared, adjusting the synthesis protocol to account for the presence of plasticizers and contaminants. They show a dense elastomeric appearance and proved to be compatible with Li metal and stable upon 600 h of Li plating/stripping. The electrochemical window is compatible with the LiFePO 4 cathode, as demonstrated by prolonged galvanostatic cycling (250 cycles) in laboratory‐scale cells. Preliminary results are highly encouraging and pave the way to developing novel separators for safe, low‐cost, and sustainable energy storage devices.
The push to use metallic lithium‐based batteries motivates a shift toward the use of solid polymer electrolytes. To improve the ionic conductivity values of such electrolytes, liquid additives (plasticizers) are usually added. However, the improvement in conductivity comes at the expense of a deterioration of the anode–electrolyte interface, resulting in poorer electrochemical cell performance. In this study, the use of a polymer coating consisting of polyethylene oxide, LiTFSI, and LiNO 3 is proposed. The coating shows improved electrochemical performance and stability, delayed cell failure and a more uniform distribution of Li deposits. These improvements are attributed to the increased stability of the solid electrolyte interphase, which is confirmed by using a combination of electrochemical impedance spectroscopy, scanning electron microscopy, and X‐ray photoelectron spectroscopy. In contrast, it is found that the interphase in uncoated Li electrodes is likely affected by continuous reactions with the plasticizer, further confirming the need to use such protective coatings to achieve long‐term operation in practical solid‐state Li metal batteries.