16 June 2022 in IEEE Transactions on Instrumentation and Measurement
To improve the accuracy of micro-coordinate measuring machines (CMMs) to nanometer scale, numerous hardware improvements have been studied and carried out in recent years, albeit with high costs and application limitations. Error compensation technology through software has also been applied because of its high precision, high efficiency, and low cost. A global volumetric error compensation model on the basis of the Abbe and Bryan principles for micro-CMMs is proposed in this study. The volumetric errors of the general CMMs were also analyzed, and the transmission relationship between the volumetric and geometric errors was established in the proposed model. The parameters in the model including 21 geometric errors and Abbe/Bryan offsets were measured and used to compensate for the volumetric errors. A zero-class gauge block was tested using a micro-CMM based on ISO 10360-2. With the volumetric error compensation, the standard deviations of the length measurements in the different diagonal directions were reduced by more than 65%. Thus, the effectiveness of the proposed method was established. This study provides a general modeling method and compensation techniques of volumetric errors for people involved in accuracy improvement for CMMs and machine tools.
10 November 2023 in IEEE Sensors Journal
Microholes with diameters less than 200 μm and aspect ratios larger than 5:1 are widely used in industrial production. To measure the inner wall of these structures with nanometer accuracy, this study proposed and implemented a method using a self-developed micro-coordinate-measuring machine equipped with a tungsten probe stylus. The probe stylus has a sphere diameter of approximately 60 μm, which makes it suitable for vertical insertion into the microholes. The self-fabricated tungsten probe tip’s radius error was measured and corrected using a ruby standard sphere. The tungsten probe stylus was fixed to the probe’s elastic mechanism and then inserted into the microhole’s interior through a vision-aided guidance system. Eight points uniformly distributed on the cross section at different heights were measured, and the coordinates of the points were fitted into a circular equation using the least-squares method. The measured diameter and roundness error were obtained from the fitted equations. Experimental results show that the measurement uncertainties of the diameter and roundness error measurement are 192 and 226 nm (K = 2), respectively. This method can provide nanometer-accurate measurements of the internal dimensions of microholes and microgrooves, as well as the dimensional and morphological characteristics of their inner walls. Equipped with a needle-tip probe, it can also be used to measure the roughness of the inner wall of microstructures.
15 July 2025 in Precision Engineering
1 January 2026 in IEEE Transactions on Instrumentation and Measurement
24 November 2025 in Precision Engineering