Models that describe two-fluid flow in porous media suffer from a widely recognized problem that the constitutive relationships used to predict capillary pressure as a function of the fluid saturation are nonunique, thus requiring a hysteretic description. As an alternative to the traditional perspective, we consider a geometric description of the capillary pressure, which relates the average mean curvature, the fluid saturation, the interfacial area between fluids, and the Euler characteristic. The state equation is formulated using notions from algebraic topology and cast in terms of measures of the macroscale state. Synchrotron-based x-ray microcomputed tomography and high-resolution pore-scale simulation is applied to examine the uniqueness of the proposed relationship for six different porous media. We show that the geometric state function is able to characterize the microscopic fluid configurations that result from a wide range of simulated flow conditions in an averaged sense. The geometric state function can serve as a closure relationship within macroscale models to effectively remove hysteretic behavior attributed to the arrangement of fluids within a porous medium. This provides a critical missing component needed to enable a new generation of higher fidelity models to describe two-fluid flow in porous media.
Saturated tabletop lasers operating at repetition rate with average powers were demonstrated at wavelengths between 16.5 and in the transitions of Ni-like ions. The results were obtained using picosecond laser heating pulses with an energy of only by optimizing the angle of incidence for maximum energy deposition. Lasing was also observed for shorter wavelength transitions of the same isoelectronic sequence, with amplification in the line of Ni-like Sn approaching gain saturation, and progressively reduced gain for wavelengths as low as for Ni-like Te. These high repetition rate soft x-ray lasers will enable new applications in science and the development of unique metrology and processing tools for industry.
We report saturated operation of an 18.9-nm laser at 5-Hz repetition rate. An amplification with a gain–length product GL of 15.5 is obtained in the laser line of Ni-like Mo in plasmas heated at grazing incidence with pulses of 8.1-ps duration from a tabletop laser system. Lasing is obtained over a broad range of time delays and pumping conditions. We also measure a GL of 13.5 in the 22.6-nm transition of the same ion. The results are of interest for numerous applications requiring high-repetition-rate lasers at wavelengths below 20 nm.
We demonstrate the generation of an intense soft-x-ray-laser beam by saturated amplification of high harmonic seed pulses in a dense transient collisional soft-x-ray-laser plasma amplifier created by heating a titanium target. Amplification in the 32.6 nm line of Ne-like Ti generates laser pulses of subpicosecond duration that are measured to approach full spatial coherence. The peak spectral brightness is estimated to be . The scheme is scalable to produce extremely bright lasers at very short wavelengths with full temporal and spatial coherence.
Efficient excitation of dense plasma columns at 100-Hz repetition rate using a tailored pump pulse profile produced a tabletop soft-x-ray laser average power of 0.1 mW at λ = 13.9 nm and 20 μW at λ = 11.9 nm from transitions of Ni-like Ag and Ni-like Sn, respectively. Lasing on several other transitions with wavelengths between 10.9 and 14.7 nm was also obtained using 0.9-J pump pulses of 5-ps duration from a compact diode-pumped chirped pulse amplification Yb:YAG laser. Hydrodynamic and atomic plasma simulations show that the pump pulse profile, consisting of a nanosecond ramp followed by two peaks of picosecond duration, creates a plasma with an increased density of Ni-like ions at the time of peak temperature that results in a larger gain coefficient over a temporally and spatially enlarged space leading to a threefold increase in the soft-x-ray laser output pulse energy. The high average power of these compact soft-x-ray lasers will enable applications requiring high photon flux. These results open the path to milliwatt-average-power tabletop soft-x-ray lasers.