1 February 2019 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Recently, analog and mixed-signal neural network processors have been extensively studied due to their better energy efficiency and small footprint. However, analog computing is more vulnerable to circuit nonidealities such as process variation than their digital counterparts. On-chip calibration circuits can be adopted to measure and compensate for those effects, but it leads to unavoidable area and power overheads. In this brief, we propose a variation and noise-tolerant learning algorithm and postsilicon process variation compensation technique which does not require any additional monitoring circuitry. The proposed techniques reduce the accuracy degradation in the corrupted fully connected network down to 1% under large amount of variations including 10% unit capacitor mismatch, 8-mVrms comparator noise and 20-mVrms comparator offset.
7 July 2020 in IEEE Transactions on Circuits and Systems II: Express Briefs
This paper proposes a fully integrated output capacitor-less low-dropout regulator (LDO) using a voltage difference to time converter (VDTC). Proposed dynamic amplifier based VDTC allows low voltage operation and significantly reduces the quiescent current. The linear characteristics of VDTC result in output ripple-less operation and good regulation performance. Using direct output feedback through a small coupling capacitor, the gate voltage of the power transistor is instantly compensated to mitigate fluctuation of the output voltage when a sharp load transient occurs. Fabricated in 65 nm LP CMOS, the proposed LDO demonstrates a wide operation range with an input voltage range of 0.6-1.2 V and a load current of over 30 mA across all voltages without an output capacitor. With reduced output impedance due to direct output feedback, the measured undershoot is 158 mV, which is recovered in 9.6 μs, when the load current changes by 28 mA in 1 ns. The peak current efficiency is more than 99.99% and the figure of merit (FOM) is 0.202 fs. The active area of the control block is 0.002 mm2.
3 March 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
Spiking neural networks are a promising candidate for next-generation machine learning and are suitable for powerconstrained edge devices. In this paper, we present a mixed-signal neuromorphic processor that efficienctly implements an echo state network (ESN) and achieves high accuracy without a costly on-chip training process. The design employs a charge-domain computation circuit that efficiently realizes a leaky integrate and fire neuron. Combined with optimizing sparse connections, the proposed algorithm-hardware co-design approach results in a highly energy-efficient operation while delivering high accuracy. Fabricated in a 65nm LP process, the processor is measured to achieve 95.35% MNIST classification accuracy, which closely matches the software model, and energy efficiency of 12.92nJ per classification.
17 December 2025 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
High-bandwidth memory (HBM) has enabled substantial advancements in bandwidth-intensive applications, including large-scale artificial intelligence models. HBM is typically integrated with other systems-on-chip (SoCs) through a silicon interposer, and the primary bottleneck in aggressively scaling the bandwidth in next-generation HBM systems stems from significant crosstalk caused by closely spaced, high-density parallel interconnects in the interposer. While crosstalk avoidance code (CAC) has emerged as a promising solution, prior CAC schemes suffer from low bit efficiency and considerable hardware overhead. This article proposes an efficient CAC scheme, WITCH, which employs a novel weighted coding strategy. Unlike prior approaches that consider all channels identically, WITCH assigns different weights to channels based on their relative positions in the array, enabling more bit-efficient crosstalk suppression. We also present WITCH with additional shielding (WITCH-AS), an extension of WITCH that incorporates additional shielding to further reduce crosstalk levels. Our coding schemes achieve high bit efficiency, up to 17.3% higher than state-of-the-art techniques while providing an identical level of crosstalk reduction. Simulation results using an industry-proven channel model demonstrate that WITCH and WITCH-AS improve eye height by 10.1%–49.4% and 17.1%–51.1%, respectively. Furthermore, we propose an area- and energy-efficient hardware implementation that can be integrated into real-world HBM systems. The design reduces area and critical path delay by 31.0% and 28.2%, respectively, compared with conventional designs. Finally, we propose a compatible simultaneous switching output (SSO) noise mitigation technique that can be seamlessly integrated into WITCH to further enhance signal integrity under high-speed, high-density operating conditions.