25 December 2019 in IEEE Electron Device Letters
In this letter, a fan-out-package-embedded power inductor technology is proposed. The inductor is embedded in a silicon-based fan-out package and surrounds the packaged die in which a voltage converter IC can be put. To demonstrate the integrated power inductor technology, a 2.4-nH air-core inductor for integrated voltage regulator applications is fabricated. The fabricated inductor shows a dc resistance of 5.0 mΩ and quality factors of 43–67 in the frequency range of 100–500 MHz. The small dc resistance and high quality factors make this integrated inductor technology promising for integrated power conversion.
25 October 2012 in Solid-State Electronics
15 November 2019 in IEEE Electron Device Letters
24 March 2012 in Applied Physics A
Charge-trapping characteristics of stacked LaTiON/LaON film were investigated based on Al/Al2O3/LaTiON-LaON/SiO2/Si (band-engineered MONOS) capacitors. The physical properties of the high-k films were analyzed by X-ray diffraction, transmission electron microscopy and X-ray photoelectron spectroscopy. The band profile of this band-engineered MONOS device was characterized by investigating the current-conduction mechanism. By adopting stacked LaTiON/LaON film instead of LaON film as charge-trapping layer, improved electrical properties can be achieved in terms of larger memory window (5.4 V at ±10-V sweeping voltage), higher program speed with lower operating gate voltage (2.1 V at 100-μs +6 V), and smaller charge loss rate at 125 °C, mainly due to the variable tunneling path of charge carriers under program/erase and retention modes (realized by the band-engineered charge-trapping layer), high trap density of LaTiON, and large barrier height at LaTiON/SiO2 (2.3 eV).
22 December 2015 in IEEE Transactions on Electron Devices
In this paper, an analytical model for calculating the ac resistance due to the proximity effect in thick coil integrated spiral inductors is proposed. Based on 2-D Maxwell's equations, the redistribution of magnetic field and current in the coils caused by the proximity effect is modeled, and the ac resistance of the inductor is extracted. The analytical model is compared with both numerical simulations and experimental results. The ac resistance calculated by the model is good (within 14.8% discrepancy) up to the frequency of the peak quality factor for thick coil integrated spiral inductors.
8 May 2020 in IEEE Transactions on Electron Devices
In this article, a trench-field-plate (TFP) high-voltage power MOSFET is proposed. Instead of using a conventional n⁻ drift region, the TFP power MOSFET features benzocyclobutene dielectric in the sidewall of deep trenches in the drift region and a sloped field plate (FP) inside each of the trenches. The TFP structure employed in the drift region modulates the electric field in the off-state, resulting in a higher breakdown voltage (BV) than that of conventional power MOSFETs. Simulation results show that the specific on-resistance of the TFP power MOSFET is approximately one-third that of the conventional power MOSFET and about 50% lower than that of the silicon limit for the same BV. In addition, compared with superjunction devices, the TFP power MOSFET is able to provide better reverse recovery characteristics, including a reduction in peak reverse recovery current (IRRM) and reverse recovery charge (QRR ) by 24% and 37%, respectively. Moreover, a p-i-n diode employing the TFP structure is fabricated, which is essentially identical to a power MOSFET in the off-state, to demonstrate the BV characteristics. The fabricated TFP p-i-n diode has a BV of 522 V, which is 2.3 times that of a conventional p-i-n diode fabricated on the same substrate.