31 July 2023 in Virtual and Physical Prototyping
24 November 2024 in Virtual and Physical Prototyping
21 July 2025 in Materials Science and Engineering: A
1 January 2022 in SSRN Electronic Journal
One of the most revolutionary aspects of Laser Powder Bed Fusion (LPBF) is to be able to lift the design constraints from conventional manufacturing. It allows for the proliferation of complex geometries engineered for individual applications, which implies complex geometric surfaces. However, it is widely regarded as a rule of thumb that any surfaces lower than 45° would need to be redesigned for LPBF or require sacrificial supports in order to complete the build. Removing these supports is time-consuming or often impossible since access to supports is not always possible. For many high-performance components, the drawbacks of redesigning or the use of support may outweigh the benefits of using LPBF. The purpose of this work is to study the formation of the fundamental building block of overhang – 1st layer overhang, which has not been previously reported. This research demonstrates that large 1st layer overhangs of IN718 in a disc form of 6 mm can be printed with a coverage above 90%, which is then proven vital to accelerating the transition to the quasi-steady state. For the first time, the parameter space of laser power, scan speed and hatch spacing for the 1st layer overhang has been simultaneously explored efficiently with our experimental design. A small hatch spacing and high scan speed are required while the laser power is slightly lowered for the proper formation of the 1st layer overhang. Outside of the process window, discontinuous layer is associated with low Volumetric Energy Density (VED) whereas severe balling is observed with high VED. To further quantify the formation of the 1st layer overhang, an in-situ high-speed thermal camera is used to capture the thermal characteristics of and around the melt pool of the large overhang at 1 ms interval. It is, for the first time, experimentally determined that the maximum temperature of the melt pool of the 1st layer by the core parameter is lower than that of the bulk with a larger instability, evidenced by the statistical distributions of the maximum temperature. The severe balling mechanism as a result of multiple tracks is explained with the time-series thermal images. It is observed that the consolidated melt by the unstable melt pool from the previous track coalesces with the current unstable melt pool, constituting severe balling. We propose and illustrate the use of rate of change of Heat Affected Zone (HAZ) for the selection of the adaptive parameter. It is found that Adaptive Parameter 28 (AP28) is the best choice as it reaches its plateau well before the end of the 1st layer overhang, compared with that of Adaptive Parameter 54 (AP54). Also, the 1st layer overhangs by AP54 and AP28 enable for a faster transition to its quasi-steady state in 3 layers while it takes 11 layers for the 1st layer overhang produced with the core parameter.