1 January 2014 in Procedia Engineering
The hole expansion ratio is a key indicator to evaluate stretch flanging performance of steel sheets, which is usually obtained by hole expanding test using cylindrical or conical punch. According to ISO 16630-2009(Metallic materials -- Sheet and strip -- Hole expanding test), hole expanding tests of 15 types of steel sheet were conducted using conical punch. The results indicated that there was obvious correlation between hole expansion ratio and tensile strength. While the tensile strength of steel is less than 700MPa, hole expansion ratio of steel decreases linearly with the increase of tensile strength. While the tensile strength is greater than 700MPa, hole expansion ratio tends to a constant value (about 30∼40%). Steels with tensile strength of 700MPa or more, including DP780, DP980, MS1180, have a common characteristic that they have relatively high volume of the hard phase (martensite phase). Therefore, it can be considered that, with large different deformation capacity during the forming process, the two-phase (ferrite & martensite) interface of these steels is prone to crack and expand. When the hard phase (martensite) reaches a certain volume fraction, there may be a limit of the damage energy during the microscopic damage of the two- phase interface
1 January 2017 in Procedia Engineering
1 November 2019 in IOP Conference Series: Materials Science and Engineering
The constitutive relationship between stress and strain is one of the important issues in numerical simulation of metal forming. For steel, there are two kinds of constitutive models wildly used. One is power law like Ludwik and Swift. The other is saturation models like Voce and Hockett-Sherby. It is necessary to determine the most appropriate model and parameters for newly developed high strength steels. In order to describe the ultra-high strength dual phase and quenching and partitioning steels, uniaxial tensile tests with the aid of digital image correlation techniques were performed to analyse the strain field over the whole gauge section as well as the element close to the necking point. Through experimental data analysis and numerical fitting, the validity of different models have been confirmed. It shows that equation of Hockett-Sherby model has the best fitting accuracy and high strength steels require a model with more parameters. The extrapolated weighting coefficient of combined Swift and Hockett-Sherby models is characterized, which is proved to improve the accuracy of the numerical simulation of forming of ultra-high strength steels based on the conventional tensile tests.
1 January 2022 in Materials Science and Engineering: A
1 June 2016 in Journal of Iron and Steel Research International