11 September 2023 in IEEE Transactions on Electromagnetic Compatibility
This article introduces a comprehensive methodology for analyzing common-mode (CM) ferrite chokes in time-domain (TD) methods, employing lumped dispersive loads, and validates it through a typical test setup for cable crosstalk assessment. The analysis begins with the experimental characterization of CM choke material properties using a coaxial line fixture to obtain its constitutive parameters. Subsequently, a simplified lumped dispersive convolutional model is obtained, representing the impedance of the ferrite when placed on a location on the cable. The first approach adopts a multiconductor transmission line (MTL) model for the cables, solving them by a finite-difference (FDTD) space-time scheme. The second approach utilizes the classical full-wave Yee-FDTD method in conjunction with the thin-wire Holland model for cables. The accuracy of the proposed methods is evaluated by comparing simulations performed with MTL-FDTD and Holland-Yee FDTD, to experimental measurements, and results obtained with the the frequency-domain finite element method using a 3-D model of the ferrite with its constitutive parameters. Finally, the validity and performance of the methodologies are critically discussed.
8 January 2024 in IEEE Transactions on Power Electronics
An impedance model, based on transmission line theory, is introduced for common mode ferrite chokes. The proposed model takes into account the geometrical properties of the choke, the distribution of electromagnetic fields within the core material and the impact of the measurement setup. The validity of the model was tested through numerical simulations. As a practical application, the model was applied to estimate the complex permeability of manganese zinc (MnZn) and nickel zinc (NiZn) cores from impedance measurements, resulting in a range of values compatible with those reported in other works.
13 May 2024 in IEEE Transactions on Power Electronics
This paper presents a full-wave 3-D FEM simulation methodology for magnetic toroidal cores up to 100 MHz. 3-D FEM simulation of magnetic toroidal cores has gained significant relevance in recent years. However, the use of magnetic materials in simulation presents some difficulties. Complex permeability is typically the only electromagnetic property used in magnetic toroidal cores' simulation. Nonetheless, recent results suggest that other properties must also be considered in high-frequency simulations. The presented methodology is particularly practical as it accurately models commercial cores easily. Electromagnetic properties valid for simulation are directly extracted from the cores with two simple setups. No complex fixtures or sample modification are required. Two ferrites (MnZn and NiZn) and a nanocrystalline core are studied. Complex permeability is characterized with a largely used method, and complex permittivity is extracted directly from the cores using the parallel plate capacitor method. With this methodology, cores' electromagnetic models are achieved, which are validated by comparing 3-D FEM simulations of several inductors with their measurements. Results lead to a simple and practical methodology to perform small-signal cores simulation in linear zone up to 100 MHz, which had not been achieved so far.