Yang Liu

Yang Liu

Auto-generated profile, based on publicly available information

Yang Liu

School of Emergency Management and Safety Engineering, China University of Mining and Technology (Beijing), Beijing, China

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 May 2022 in Fire Safety Journal
Verified
Journal Article
Closed access
YLYang Liu
Yang Liu
ZFZhixi Fu
Zhixi Fu
GZGuanghui Zheng
Guanghui Zheng
PCPeng Chen
Peng Chen

26 October 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
YLYang Liu
Yang Liu
XYXing Yang
Xing Yang
ZFZhixi Fu
Zhixi Fu
RSRuibang Sun
Ruibang Sun
In this paper, a coupled new solver is used to simulate the acceleration and deflagration to detonation transition (DDT) of inhomogeneous mixtures flame under obstacle conditions. Analyzed the variations of flame front, pressure and density with time. The experimental results show that the vertical concentration gradient affects the chemical reaction rate in the combustion reaction zone, resulting in the flame front stretching along the “front up-back down.” At the same time, the flame propagation velocity is affected by obstacles. After multi-stage “acceleration-deceleration,” it reaches 2700 m/s at 1.23 m from the ignition center, and the pressure jumps to 5.0 MPa. Finally, the transition from detonation to detonation is completed. It is worth noting that the local explosion point is in the corner of the obstacle or pipe wall. This simulation method is compatible with low Mach number laminar flow, turbulent flow, and compressible reaction flow problems under high Mach number. It provides prospective prediction for flame acceleration and detonation formation during hydrogen combustion and detonation engine operation.

27 December 2022 in Combustion Science and Technology
Verified
Journal Article
Closed access
RSRuibang Sun
Ruibang Sun
RSRuibang Sun
Ruibang Sun
LLLiyang Li
Liyang Li
YLYang Liu
Yang Liu
XZXu Zhai
Xu Zhai
Liquid jet fire was one of the typical fires that endangered industrial safety. Especially, the oil-filled equipment of the substation was subjected to an external thermal load, which caused liquid jet fire. However, less literature was available for the formation mechanism of liquid jet flame. Thus, this paper conducted a systematic experiment to reveal the formation mechanism of transformer oil jet fire with various heat release rates (33 kW, 73 kW, 132 kW, and 212 kW). In this paper, the formation mechanism of transformer oil jet fire was clarified. Experimental observation showed that the formation process of transformer oil jet fire can be divided into three stages. The gas–liquid two-phase flow occurred during the formation of transformer oil jet fire. The correlation between the overpressure peak and the heat release rate was established. The medium thermal response behavior can be divided into three stages. When the medium temperature reached the boiling point, the jet fire appeared. The thermal stratification model of a transformer oil jet was established. The correlation between the degree of liquid stratification and dimensionless heat release rate was established. The thermal convection and radiation determined the heat transfer mechanism of oil during the formation of jet fire.