13 April 2020 in Advances in Structural Engineering
When performing railway track stiffness analyses, in current standards sleepers are often regarded as a rigid member. For flexible sleeper materials like timber or polymers, this may lead to underestimating rail deflections up to a factor two and overestimating rail seat loads up to 20%. Calculations incorporating sleeper bending can currently be performed analytically by a two-layer beam-on-elastic-foundation calculation, or by finite element analyses, but a simple approach does not yet exist. This article introduces a simple calculation method to establish rail deflections, track stiffness and rail seat loads, incorporating the effects of both bending and shear stiffness of the sleeper, applicable to new or tamped track. A sleeper flexibility factor f S is introduced as a deformation multiplication factor compared with a rigid sleeper. Validation against current calculation models shows a deformation accuracy within 6% and a load accuracy within 2%. When a track is not maintained, a gap will develop under the sleeper at the rail seat. The size of this gap correlates to the stiffness of the sleeper. Eventually a uniform load distribution can develop under the sleeper. A calculation method is introduced to estimate the gap and the track behaviour at uniform load distribution. When for flexible sleepers the track deflection due to the gap can develop outside of the desired range, timely track maintenance or monitoring is advised.
15 September 2021 in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
Before a new type of railway sleeper can be used in track, standardised laboratory tests must be carried out to determine its suitability. In addition to static load tests, assessments usually include cyclic load tests consisting of millions of load cycles, representing passing trains during the sleeper’s service life. In these laboratory tests, the loading cycles are applied continuously without resting periods to condense the test time. Traditional sleeper materials (timber, concrete) possess elastic properties for which such testing is appropriate. However, polymer sleepers exhibit viscoelastic properties, such as creep, a loading rate-dependent stiffness and heating due to non-linearity of the stress-strain curve. Subjecting polymer sleepers to continuous cyclic load tests with a load frequency reflecting permissible track speed can cause the sleeper to heat up. Intermittent testing with pauses between numbers of load cycles is proposed in this paper as a possible solution. The aim is to propose a laboratory loading procedure that adopts a traffic-resembling load of a railway line, considering an effective compromise between polymer visco-elastic behaviour and time consumption of the laboratory tests. The loading frequency is kept at the desired strain rate for track evaluation, giving a representative sleeper stiffness and strength assessment. Exemplary tests with varying test arrangements and loading procedures were performed to quantify the effects of intermittent loading in comparison with continuous loading. The proposed method eliminated most of the test-induced creep and heat accumulation, resulting in a more representative stiffness and strength assessment, which justifies the proposed intermittent testing for polymer sleepers. The proposed intermittent procedure is an optional test regime in ISO 12856-2 for polymer sleeper testing.