Judiciously matched experiments, calculations, and theory demonstrate that a higher sensitivity to short-range interactions and, consequently, improved resolution on the atomic scale can be achieved by bimodal noncontact dynamic force microscopy. The combination of sub-Ångström tip oscillation at the second flexural resonance of a commercially available silicon cantilever with the commonly used large amplitude oscillation at the fundamental resonance frequency enables this performance improvement while avoiding potentially damaging jump-to-contact instabilities.
The three-dimensional force field above an NaCl(001) surface was measured on a fine grid by small amplitude dynamic force spectroscopy at room temperature. After careful drift corrections, maps in nominally equivalent symmetry planes as well as in sections parallel to the surface reveal distance-dependent shifts of characteristic atomic-sized features. These shifts reflect asymmetries of the probing tip apex but are mainly due to atomic displacements induced by short-range forces. In addition, weak decaying force oscillations with a period close to the interlayer spacing are detected at distances where no atomic-scale variations are expected. Stronger site-dependent changes appear in the interaction-induced energy dissipation.
Contacting single molecules and molecular assemblies and determining optoelectronic properties is one of the most challenging topics in the field of molecular electronics. According to this purpose, the contacting of one- and two-dimensional molecular assemblies of asymmetric cyanoporphyrins and Au nanoclusters was developed. Furthermore, Kelvin probe force microscopy gives the opportunity to access electronic properties of the molecular assemblies and to distinguish the molecules from Au nanocontacts. The change in the dipole moment density related to geometrical changes within a molecular wire contacted by two Au nanoclusters on a KBr single crystal substrate is observed and analyzed.