State Key Laboratory of Optoelectronic Materials and Technologies, School of Electronics and Information Technology, Sun Yat-Sen University, Guangzhou 510006, China
Auto-generated profile, based on publicly available information
Yangbing Xu
State Key Laboratory of Optoelectronic Materials and Technologies, School of Electronics and Information Technology, Sun Yat-Sen University, Guangzhou 510006, China
The integration of perovskite photodetectors with thin-film transistor (TFT) backplane or complementary metal-oxide-semiconductor CMOS circuit is a key step towards prototyping perovskite-based image sensors. Here, we demonstrate a pixel configuration for indirect X-ray detection comprising of IGZO TFTs and perovskite photodiodes (PDs). The perovskite photodiode is patterned by a two-step deposition method. Our integrated TFT/PD pixel shows a weak light detection capability down to 4 nW cm-2, and a fast-transient response to the pulse light and gate switching. Combining with a CsI scintillator, the integrated pixel achieves a specific X-ray sensitivity of 8.2 × 102 μC mGyair-1 cm-3. Theoretically, with a state-of-the-art scintillator, the new pixel can provide a detectable signal for X-ray imaging at a dose rate as low as 10 μGyair s-1. This work provides an advanced pixel design for high resolution, high sensitivity, and high frame-rate flat-panel imager.
This paper reports on a highly-sensitive indirect-conversion X-ray detector with an embedded photodiode formed by a scintillator-coupled three-dimensional photosensitive thin-film transistor. A high X-ray sensitivity up to $2.5 \times 10^5 \mu \text{C}\cdot \text{Gy}^{-1}\cdot \text{cm}^{-2}$ at a dose of 1 mGy is achieved due to full photon utilization and a high photo gain of $\sim 10^4$ by operating it in an active pixel sensor format. These performance characteristics make it a great promise for low-dose and high-spatial resolution large-area indirect-conversion X-ray detection.
A conventional large-area indirect-conversion X-ray detector usually adopts front side illumination (FSI) of a scintillator atop a photodiode-integrated thin-film transistor (TFT) array. This work however proposes a backside illuminated (BSI) three-dimensional dual-gate photosensitive a-Si:H TFT (3-D DGTFT) on a scintillating glass substrate, aiming for indirect-conversion X-ray detection. It not only improves the sensitivity with a 3-D photosensitive TFT as an active pixel sensor, but also enhances the resolution and photon utilization by reducing photon scattering and optical crosstalk. Backside illumination of 3-D photosensitive TFT-integrated scintillating glass therefore provides an alternative approach to large-area indirect-conversion X-ray imaging.
Medical X-ray computed tomography requires fast imaging at a low dose rate and in a large area. Halide perovskites have shown high potential for X-ray detection, but a pressing challenge is the current lack of low-cost methods for large-scale fabrication of high-quality thick perovskite films. Here we demonstrate and elucidate an aerosol-liquid-solid process to enable continuous growth of uniform halide perovskites films at low temperature over a large area of 100 cm2, which are vertically monolithic and monocrystalline, and thus beneficial to carrier transport. Direct conversion X-ray detectors based on the representative CsPbI2Br films in conjunction with a deliberated, interface-engineered C-electrode have realized an unprecedented sensitivity (≥1.48×105 μC Gyair−1cm−2). We have further demonstrated the high-resolution radiographic imaging capability of these films. These results lay the groundwork for large scale application of halide perovskites in radiation detectors.