We report on the fabrication and characterization of an 8 × 8 multichannel Boron Doped Diamond (BDD) ultramicro-electrode array (UMEA). The device combines both the assets of microelectrodes, resulting from conditions in mass transport from the bulk solution toward the electrode, and of BDD’s remarkable intrinsic electrochemical properties. The UMEAs were fabricated using an original approach relying on the selective growth of diamond over pre-processed 4 inches silicon substrates. The prepared UMEAs were characterized by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The results demonstrated that the electrodes have exhibited a very fast electrode transfer rate (k0) up to 0.05 cm∙s−1 (in a fast redox couple) and on average, a steady state limiting current (in a 0.5 M potassium chloride aqueous solution containing 1 mM Fe(CN)64− ion at 100 mV∙s−1) of 1.8 nA. The UMEAs are targeted for electrophysiological as well as analytical applications.
The early developments of an optical gas sensor combining plasma ignition by silicon electrode arrays and optical detection coupled with image processing are presented in this paper. The principle of the sensor under development is based on the ionization of chemical species under intense electrical fields and the detection by optical sensors of photons created by glow discharges. Electrodes optimization by electrostatic simulations has led to the design and fabrication of micromachined silicon igniters bonded to a glass substrate. First characterizations of the plasma igniters will be also presented.
A new low loss and low cost microstrip MEMS technology is presented. Two inverted microstrip lines, one on low loss silicon and the other on glass have been measured and simulated. A good concordance of the results has been obtained. Simulations have been used to study the influence of several parameters, and the results of simulations allow us to adjust the lines dimensions to prescribed characteristics.