29 October 2013 in Microsystem Technologies
18 November 2022 in IEEE Sensors Journal
In this study, drift of microelectromechanical system (MEMS) accelerometers stored at room temperature for one year is investigated by both finite element analysis (FEA) simulation and experiments. In the simulation, a comprehensive FEA model considering the die-attach adhesive viscoelasticity was established to emulate the deformation of the sensor package structure during storage. Then drift models of scale factor and bias of the accelerometer were built according to the deformed structure. To validate the simulation results, several accelerometers were packaged and their outputs were tested and recorded once per month. The two parameters displayed a continuous drift owing to the release of the packaging stress in the chip. The scale factor drifts were negative and about 2500 ppm for different types of the sensors. However, the bias drifts were positive or negative, and their magnitudes were ranging from 12 mg to 32 mg in storage. Moreover, they reached a steady state after about 10 months (<50 ppm per month for scale factor) and 6 months (<1 mg per month for bias) room temperature storage. The results in this paper provide meaningful guidance for the application of MEMS accelerometers.
26 July 2021 in IEEE Transactions on Instrumentation and Measurement
In this work, the drifts of the bias and scale factor induced by the dielectric charging are studied for micro-electro-mechanical system (MEMS) closed-loop accelerometers. At first, the equations of the feedback electrostatic forces, including the built-in voltages resulted from the dielectric charging, are built up for the two capacitors of the accelerometers. Then, the models for the drifts of the bias and scale factor both are established. Based on the models and experimental data, it is found that the drift of the scale factor is always negative because the built-in voltages always decrease the scale factor. However, the drift of the bias can be negative or positive because it is in proportion to the built-in voltages' difference of the two capacitors, which may be negative or positive. The major output error for the small input acceleration is caused by the drift of the bias. However, for the large acceleration, the error induced by the drift of the scale factor is also vital. Finally, the method of choosing the frequency of the ac reference voltage for suppressing the dielectric charging based on the drift of the scale factor is established. The feasibility is verified by the experimental data.
1 April 2018 in International Journal of Adhesion and Adhesives