Within the silicon photovoltaics (PV) community, there are many approaches, tools, and input parameters for simulating solar cells, making it difficult for newcomers to establish a complete and representative starting point and imposing high requirements on experts to tediously state all assumptions and inputs for replication. In this review, we address these problems by providing complete and representative input parameter sets to simulate six major types of crystalline silicon solar cells. Where possible, the inputs are justified and up-to-date for the respective cell types, and they produce representative measurable cell characteristics. Details of the modeling approaches that can replicate the simulations are presented as well. The input parameters listed here provide a sensible and consistent reference point for researchers on which to base their refinements and extensions.
21 September 2017 in IEEE Journal of Photovoltaics
Many manufacturers choose the passivated emitter and rear cell (PERC) approach in order to surpass the 20% cell efficiency level in mass production. In this paper, we study the efficiency potential of the PERC approach under realistic assumptions for incremental improvements of existing technologies by device simulations. Based on the most recent published experimental results, we find that the PERC structure is able to reach about 24% cell efficiency in mass production by an ongoing sequence of incremental improvements. As a guideline for future developments, we provide a method to improve cell efficiency most effectively by monitoring the current losses at the maximum power point. By means of numerical device modeling, we identify some key technologies toward 24% efficient PERC cells and provide its technology-related target requirements.
We measure and discuss the complex refractive index of conventional ethylene vinyl acetate (EVA) and an EVA with enhanced UV-transmission based on spectroscopic ellipsometry, transmission and reflection measurements over the wavelength range from 300-1200 nm. Ray tracing of entire solar cell modules using this optical data predicts a 1.3% increase in short circuit current density (Jsc) at standard test conditions for EVA with enhanced UV transmission. This is in good agreement with laboratory experiments of test modules that result in a 1.4% increase in Jsc by using a UV transparent instead of a conventional EVA. Further, ray tracing simulations with realistic irradiation conditions with respect to angular and spectral distribution reveal an even larger Jsc increase of 1.9% in the yearly average. This increase is largest in the summer months with an increase of up to 2.3%
1 October 2018 in Solar Energy Materials and Solar Cells
The phosphosilicate glass (PSG), fabricated by tube furnace diffusion using a POCl3 source, is widely used as a dopant source in the manufacturing of crystalline silicon solar cells. Although it has been a widely addressed research topic for a long time, there is still lack of a comprehensive understanding of aspects such as the growth, the chemical composition, possible phosphorus depletion, the resulting in-diffused phosphorus profiles, the gettering behavior in silicon, and finally the metal-contact formation. This paper addresses these different aspects simultaneously to further optimize process conditions for photovoltaic applications. To do so, a wide range of experimental data is used and combined with device and process simulations, leading to a more comprehensive interpretation. The results show that slight changes in the PSG process conditions can produce high-quality emitters. It is predicted that PSG processes at 860 °C for 60 min in combination with an etch-back and laser doping from PSG layer results in high-quality emitters with a peak dopant density Npeak = 8.0 × 1018 cm−3 and a junction depth dj = 0.4 μm, resulting in a sheet resistivity ρsh = 380 Ω/sq and a saturation current-density J0 below 10 fA/cm2. With these properties, the POCl3 process can compete with ion implantation or doped oxide approaches.