Re-poling of unexpected partially depoled piezoelectric materials conventionally needs to be first fully depoled through annealing above their Curie temperature to revive piezoelectric performances. Here, we investigated de-poling and re-poling of Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3 single crystals under electric fields at room temperature. We found that alternating current electric fields with amplitudes near the coercive field at low frequencies (<10 Hz) can be employed to successfully depolarize poled crystals at room temperature. We also demonstrated a reversible polarization switching process with a relaxor-PbTiO3 single crystal ultrasound transducer without device performance degradations. This experimental observation is supported by phase-field simulation, showing that alternating current electric fields can readily induce de-poling at room temperature, while direct current electric fields induce a transient depoled state only within an uncontrollable short period of time. The findings suggest new strategies for unprecedented in-device tailoring of the polarization states of ferroelectric materials.
This study investigated the dielectric and piezoelectric properties of third-generation Mn-doped Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 (Mn: PIN-PMN-PT) single crystals with varying PT content using alternating current poling (ACP) and direct current poling (DCP) at room temperature. Ten types of samples were taken sequentially from the top to the bottom of the crystal ingot, with Mn and PT content decreasing accordingly. The ACP method demonstrated the highest PT content sample on top, yielding a piezoelectric constant of (d33) 2280 pC/N, piezoelectric voltage constant (g33) of 41.8 × 10−3 Vm/N, and a dielectric constant (ε33T/ε0) of 6150, which are significantly higher (60% for d33, 84% for ε33T/ε0) than DCP single crystals. This type of single crystal exhibited a high coercive field (Ec) reaching 4.8 kV/cm. Additionally, the results indicate that ACP enhances the mechanical quality factor (Qm), achieving a value of 700. d33 and ε33T/ε0 of these two poling methods were examined from room temperature to beyond the Curie temperature. This study provided valuable insights into optimizing poling strategies to achieve enhanced performance for Mn: PIN-PMN-PT single crystal piezoelectric devices.
Ferroelectric domain walls separate regions of uniform polarization in ferroelectric materials, and their controlled manipulation, such as through electric poling, is essential for enhancing the electromechanical performance of advanced ferroelectric devices. While most existing imaging techniques only examine static domain structures at the pre- or post-poling state, real-time, in situ, and non-destructive visualization of internal domain wall dynamics during electric poling using a simple implementation remains a significant challenge. In this work, we present a simple and accessible optical technique, instant polarized light microscopy (IPOLπ), for through-volume, single-shot, and in situ observation of domain wall evolution during electric poling. Demonstrated on [110]-oriented Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 single crystals, IPOLπ enables direct observation of polarization dynamics during alternating current poling and electrical depoling. The method reveals the formation of layered domain structures initiating at sample edges and progressing inward, as well as the correlation between optical birefringence changes and electrical current response. This low-cost, robust technique provides a powerful tool for studying real-time domain wall behavior, offering new insights into structure–property relationships in functional ferroelectric crystals.