Deng Wang

Deng Wang

Auto-generated profile, based on publicly available information

Deng Wang

Department of Materials Science and Engineering City University of Hong Kong Kowloon Hong Kong SAR 999077 China

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 February 2024 in Science
Verified
Journal Article
Closed access
PZPeide Zhu
Peide Zhu
DWDeng Wang
Deng Wang
YZYong Zhang
Yong Zhang
ZLZheng Liang
Zheng Liang
JLJingbai Li
Jingbai Li
BXBaomin Xu
Baomin Xu
High-purity precursor materials are vital for high-efficiency perovskite solar cells (PSCs) to reduce defect density caused by impurities in perovskite. In this study, we present aqueous synthesized perovskite microcrystals as precursor materials for PSCs. Our approach enables kilogram-scale mass production and synthesizes formamidinium lead iodide (FAPbI 3 ) microcrystals with up to 99.996% purity, with an average value of 99.994 ± 0.0015%, from inexpensive, low-purity raw materials. The reduction in calcium ions, which made up the largest impurity in the aqueous solution, led to the greatest reduction in carrier trap states, and its deliberate introduction was shown to decrease device performance. With these purified precursors, we achieved a power conversion efficiency (PCE) of 25.6% (25.3% certified) in inverted PSCs and retained 94% of the initial PCE after 1000 hours of continuous simulated solar illumination at 50°C.

4 October 2021 in Advanced Functional Materials
Verified
Journal Article
Closed access
PDF file
DWDeng Wang
Deng Wang
HGHongling Guo
Hongling Guo
XWXin Wu
Xin Wu
XDXiang Deng
Xiang Deng
FLFengzhu Li
Fengzhu Li
AJAlex K.‐Y. Jen
Alex K.‐Y. Jen

16 November 2024 in Advanced Materials
Verified
Journal Article
Closed access
DWDeng Wang
Deng Wang
MCMingqian Chen
Mingqian Chen
XLXia Lei
Xia Lei
YWYunfan Wang
Yunfan Wang
YBYuqi Bao
Yuqi Bao
AJAlex K.‐Y. Jen
Alex K.‐Y. Jen

28 February 2022 in Journal of Electrochemical Science and Technology
Verified
Journal Article
Open access
PDF file
LZLiben Zhou
Liben Zhou
WCWeizhong Cheng
Weizhong Cheng
DWDeng Wang
Deng Wang
ZLZhaolei Li
Zhaolei Li
HZHaijun Zhou
Haijun Zhou
WGWeijie Guo
Weijie Guo
The synergistic effect of 2-chloromethylbenzimidazole (2-CBI) and potassium iodide (KI) for mild steel in 1 M hydrochloric acid solution was investigated by potentiodynamic polarization curves and electrochemical impedance spectroscopy (EIS). The results showed that, with the addition of 100 ppm potassium iodide, the inhibition efficiecy (IE) of 100 ppm 2-CBI in 1 M hydrochloric acid had been improved from 91.14% to 96.15%. And synergistic parameter of 100 ppm 2-CBI with different amounts of potassium iodide is always greater than 1. The adsorption of potassium iodide combining with 100 ppm 2-CBI obeys to the Langmuir adsorption isotherm. Thermodynamic adsorption parameters, including ΔG0ads, ΔHa and ΔSa of the adsorption of the combinned inhibitor, as well as the Ea of the mild steel corrosion in 1 M HCl with the combinned inhibitor, were calculated.

1 September 2021 in Russian Journal of Electrochemistry
Verified
Journal Article
Closed access
PDF file
WGWeijie Guo
Weijie Guo
XZXUAN XUAN ZHAO
XUAN XUAN ZHAO
DWDeng Wang
Deng Wang
Yan-cheng LiYan-cheng Li
Yan-cheng Li
LZLiben Zhou
Liben Zhou
YGYanmin Gao
Yanmin Gao
—Corrosion behavior of mild steel in 1 mol/L HCl with 2-chloromethylbenzimidazole (2-CBI) and sodium molybdate (Na2MoO4) as inhibitor was studied by using electrochemical impedance spectroscopy and potentiodynamic scanning. 2-CBI was proved an effective inhibitor for mild steel in 1 mol/L HCl, while Na2MoO4 did not. With a fixed 2-CBI concentration (100 mg/L) and increasing of Na2MoO4 concentration (50 to 300 mg/L), the inhibition efficiency (IE) of the 2-CBI/Na2MoO4 complex increased first and then decreased, and the synergistic parameters of the complex were always higher than 1. When the concentration of Na2MoO4 approaches to 150 mg/L, the IE of the complex showed a maximum value as 89.0%, which was higher than that of only 100 mg/L 2-CBI as inhibitor (81.8%). This result is considered as a compelling support for understanding the mechanism of the synergistic inhibition.