We propose herein a novel optical sensing technology using liquid crystal based transducers to measure simultaneously voltage and current from overhead power lines in real time. Doing so, we implemented a proof-of-principle system based on this approach and we demonstrated not only good accuracy, but also small phase shift and adequate bandwidth for power quality and fault monitoring applications. This is supported by experimental results for current, voltage and power monitoring, which include transient measurements and show excellent agreement with commercial reference probes. The system presented in this paper has been developed for single wire earth return (SWER) lines operating at 12.7 kV or 19.1 kV, but can be adapted to work at higher or lower voltages with appropriate modifications. We conclude by discussing the calibration process improvements that would be required for the technology to meet industry standards.
Photovoltaic (PV) systems are increasingly being used. Due to ageing effects and also the trend toward higher DC voltage level, incidents of DC arc faults in PV systems are becoming more common, which have serious impacts on system stability and human safety. Parallel arcs draw high current compared to series arc faults and so detection of the latter is more challenging. This paper attempts to extract the features of DC series arc fault for condition monitoring purpose, achieved through studying the arc characteristics, carrying out simulation in Matlab/Simulink and laboratory experiments. Different arc models are investigated, and a set of parameters for the heuristic model is formulated for low current arcs. It is shown that the simulated arc by the heuristic model is consistent with experimental data. The arc noise features under electrodes' separation region and steady-arcing states with different gap width are investigated. It is found that the arc noise floor will increase after arc fault occurrence, especially for the frequency band below 50 kHz. This characteristic can be exploited for series DC arc fault detection. Moreover, frequency contents below 5 kHz are relatively more sensitive to change of air gap width.
It is costly to have a conventional three phase electricity supply system to service sparsely-populated rural areas. As a solution, the single wire earth return (SWER) network is widely used which has only one overhead conductor delivering power and the ground is used for the return path. This paper presents an on-line monitoring system, currently under development, to provide real-time power quality information of the SWER lines. The system comprises pole-mounted monitoring units distributed along the SWER feeder and relies on its own independent wireless communications platform for data transmission and control.