Magdi A. Mosa

Magdi A. Mosa

Auto-generated profile, based on publicly available information

Magdi A. Mosa

Helwan Univ, Fac Engn, Elect Power & Machines Dept, Helwan, Egypt

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2023 in Electric Power Systems Research
Verified
Journal Article
Closed access
MYMariem Y. Yousef
Mariem Y. Yousef
MMMagdi A. Mosa
Magdi A. Mosa
AAA.A. Ali
A.A. Ali
MGM. A. Abdel Ghany
M. A. Abdel Ghany
MGM.A.ABdel Ghany
M.A.ABdel Ghany

10 June 2024 in Scientific Reports
Verified
Journal Article
Open access
PDF file
SHShrouk A. Hamza
Shrouk A. Hamza
MYMariem Y. Yousef
Mariem Y. Yousef
AAA. A. Ali
A. A. Ali
SMSaid M. El Masry
Said M. El Masry
MMMagdi A. Mosa
Magdi A. Mosa
Recently, hydrogen-based distributed generators (DG) have gained significant attention for modern energy generation systems. These modem DGs are typically outfitted with power electronics converters, resulting in harmonic pollution. Furthermore, increasing the growth of modern nonlinear loads may result in exceeding the harmonic beyond the permitted level. This research proposes a framework for optimal incorporation of inverter-based distributed generation (a fuel cell connected to an AC distribution system) for minimizing power losses, enhancing the voltage profile, and limiting both total and individual harmonic distortion according to the IEEE-519 standard. In addition, for accounting system sustainability, the proposed framework considers load variation and the expected rise in demand. Therefore, the suggested framework comprises three stages, which include fundamental and harmonic power flow analysis. The first stage identifies the optimal size and location of the DG in relation to the base load operating condition. While, with the optimal DG of the first stage, the amount of harmonic pollution may violate the limits during a high level of nonlinear load penetration, as a result, the second stage resizes the DG, considering the connection bus of the first stage, to mitigate the harmonics and optimize the system at a higher level of nonlinear load penetration. Both the first and second stages are performed off-line, while the third stage optimizes the system operation during run time according to loading conditions, harmonic pollution, and the available DG capacity of the previous stages. DG’s harmonic spectrum is represented according to recently issued IEEE 1547-2018 for permissible DG’s current distortion limits. The suggested approach is applied and evaluated using an IEEE 33-bus distribution system for various combinations of linear and nonlinear loads. For run-time operation throughout the day, the presented framework reduces the energy losses from 5.281 to 2.452 MWh/day (about 53.57% energy savings). This saving is associated with voltage profile enhancement without violating the permissible standard levels of harmonics and other system constraints.

1 September 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Verified
Journal Article
Open access
PDF file
ASAbdullah M. A. Shaaban
Abdullah M. A. Shaaban
AEAdel Abdel monem Elsamahy
Adel Abdel monem Elsamahy
KAKamal A. Abed
Kamal A. Abed
MMMagdi A. Mosa
Magdi A. Mosa
Solar energy, especially photovoltaic (PV), is one of the most common renewable energy resources. Panel temperature and dust are the common problems which have a great effect on the conversion performance of PV. These problems can be alleviated by cooling and cleaning in order to improve its efficiency. This paper investigates the effect of PV cooling on the energy harvesting. The study is carried out experimentally using two similar PV panels which are subjected to the same environmental conditions and connected to similar load. The proposed cooling system is applied to one of these panels while the other is left without cooling for comparison. Five cases of water cooling are tested; surface cooling in two ways, back cooling using sprayers with and without cotton net, and hybrid cooling. The effect of cooling can be noticed from the measured load voltage and power. It is found that the surface cooling is the most effective because it achieved the best improvement comparing to others. When the panel temperature decreased from 65 to 42 °C, the load voltage increased from 32.55 to 35.8 V and the load power from 4.57 to 5.37 watts, with an improvement of about 10% and 18%, respectively.

1 February 2022 in International Journal of Advanced Engineering and Business Sciences
Verified
Journal Article
Closed access
PDF file
MMMagdi A. Mosa
Magdi A. Mosa
AAAbdelghany M. Abdelghany
Abdelghany M. Abdelghany
MGM. A. Abdel Ghany
M. A. Abdel Ghany
This paper introduces an improved method for DC link voltage regulation in pulse width modulation rectifier (PWMR) applications. The mathematical model of PWMR in synchronous reference frame is introduced. This model is used to investigate and design of DC voltage and current control loops. The current controller is designed based on modulus optimum, magnitude optimum, (MO) criteria while the voltage controller is designed based on Proportional Integral (PI) with variable structure control (VSC) concept, which is denoted as PI-VSC. In PI-VSC, the control system switches between PI and pure I controllers according to pre-defined switching function. The PI-VSC has three tuning parameters, which are the PI-controllers gains and the switching function. The PI controller gains are tuned using Symmetrical Optimum (SO) criterion, while the switching function based on the absolute error signal. To verify the validity of the proposed controller, different simulation results are obtained under different operating conditions such as reference tracking and reference regulation at different loading condition and system parameter variation as sources of disturbances. The performance of the control system using PI-VSC is compared with the fixed structure PI controller obtained from MO and SO techniques.

24 September 2024 in Polityka Energetyczna – Energy Policy Journal
Verified
Journal Article
Open access
ASAbdullah M. A. Shaaban
Abdullah M. A. Shaaban
AEAdel Abdel monem Elsamahy
Adel Abdel monem Elsamahy
KAKamal A. Abed
Kamal A. Abed
MMMagdi A. Mosa
Magdi A. Mosa