24 August 2020 in Journal of the Society for Information Display
19 March 2021 in Optics Express
In this paper, fabrication processes of a 0.55-inch 400 × 240 high-brightness active-matrix micro-light-emitting diode (LED) display using GaN-on-Si epi-wafers are described. The micro-LED array, featuring a pixel size of 20 µm × 20 µm and a pixel density of 848 pixels per inch (ppi), was fabricated and integrated with a custom-designed CMOS driver through Au-Sn flip-chip bonding. Si growth substrate was removed using a crack-free wet etching method. Four-bit grayscale images and videos are clearly rendered. Optical crosstalk is discussed and can be mitigated through micro-LED array design and process modification. This high-performance, high-resolution micro-LED display demonstration provides a promising and cost-effective solution towards mass production of micro-displays for VR/AR applications.
23 December 2022 in Photonics Research
Full-color micro-LED displays are being widely developed and regarded as a primary option in current microdisplay technologies to fulfill the urgent demands of metaverse applications in the next decade. In this paper, a monolithic full-color micro-LED microdisplay with a resolution of 423 pixels per inch is demonstrated through the integration of a blue GaN-on-Si display module and a quantum dots photoresist (QDs-PR) color conversion module. The active-matrix blue micro-LED display with a dominant wavelength of 440 nm was monolithically fabricated using GaN-on-Si epiwafers and flip-chip bonded on a custom-designed complementary metal-oxide semiconductor backplane. A color conversion module was independently fabricated on a 4-in. sapphire substrate by applying red and green QDs-PR arrays and a color filter array through the standard lithography process. Combining the blue GaN-on-Si micro-LED display module and the lithography-based QDs-PR color conversion module, a full-color micro-LED display was achieved with a wide color gamut up to 104% of the standard red, green, and blue and a maximum brightness of over 500 nits. The influence of blue light leakage resulting from the possible misalignment of flip-chip bonding and crosstalk in the bottom GaN-on-Si display was investigated in which the percentages of efficient pumping light for the blue, green, and red subpixels are around 95%, 89%, and 92%, respectively. This prototype demonstrates potential scalability and low-cost volume production of high-resolution full-color micro-LED microdisplays soon.
8 September 2014 in IEEE Electron Device Letters
Novel gallium nitride-based flip-chip light-emitting diodes (FCLEDs) with high-density distributed n-type point-contacts were designed and fabricated. With high density and uniformly distributed n-type point-contacts, the point-contact (PC) FCLEDs had higher light output power (LOP) by 18% over the reference flip-chip LED with conventional contacts fabricated from the same wafer. The forward voltage of the PC-FCLEDs was 0.16 V lower than the reference FCLED and the wall-plug efficiency was increased by 24% at the same current level. The maximum LOP of the PC-FCLEDs measured at 2.4 A was 43% more than the maximum obtained by the reference LED at 1.8 A. It was also found that the PC-FCLEDs suffered lower efficiency droop. The optical performance improvement of the PC-FCLEDs is attributed to an increase of the light extraction and the uniform carrier distribution, which results from the small and high density deeply etched holes and PCs. The electrical performance was enhanced through a minimized lateral current spreading distance.